Automatic Transmission Input Shaft Speed Sensor Connectors

Replacement Parts > Transmission Replacements > Electrical Connectors

Automatic Transmission Input Shaft Speed Sensor Connectors

Filter Options

Important: To get started, click the blue "Filter Options" button to select your vehicle and then use the filters to narrow your options.

Important: To get started, select your vehicle on the left and then use the filters to narrow your options.

What is an Automatic Transmission Input Shaft Speed Sensor Connector?

An Automatic Transmission Input Shaft Speed Sensor Connector is a device that helps to measure the rotational speed of the input shaft within a car's transmission. It is used to send a signal to the car's computer, which then monitors the speed of the vehicle.

What is the purpose of an Automatic Transmission Input Shaft Speed Sensor Connector?

The purpose of an Automatic Transmission Input Shaft Speed Sensor Connector is to measure the rotational speed of the input shaft within a car's transmission, and to send a signal to the car's computer. This signal is then used by the computer to monitor the speed of the vehicle.

How do I determine if my Automatic Transmission Input Shaft Speed Sensor Connector is faulty?

If the Automatic Transmission Input Shaft Speed Sensor Connector is faulty, it can cause symptoms such as the vehicle not shifting properly or the transmission not engaging. Additionally, the Check Engine light may be illuminated. To determine if the connector is faulty, you can use an OBD-II scanner to check for any diagnostic trouble codes (DTCs).

Can a faulty Automatic Transmission Input Shaft Speed Sensor Connector cause damage?

Yes, a faulty Automatic Transmission Input Shaft Speed Sensor Connector can cause damage to the transmission, as well as other engine components.

How do I replace an Automatic Transmission Input Shaft Speed Sensor Connector?

To replace an Automatic Transmission Input Shaft Speed Sensor Connector, you will need to:

  1. Disconnect the negative battery cable.
  2. Remove the old connector from the transmission.
  3. Install the new connector onto the transmission.
  4. Reconnect the negative battery cable.
  5. Clear any diagnostic trouble codes (DTCs
  6. with an OBD-II scanner.