Distributor Ground Lead Wires

Replacement Parts > Ignition > Primary Ignition

Distributor Ground Lead Wires

Important: To get started, click the blue "Filter Options" button to select your vehicle and then use the filters to narrow your options.

Important: To get started, select your vehicle on the left and then use the filters to narrow your options.

What are Distributor Ground Lead Wires?

Distributor Ground Lead Wires are an essential component of a vehicle's ignition system that provides a ground path for the distributor to ensure proper ignition timing and engine performance.

What is the purpose of Distributor Ground Lead Wires?

The purpose of the Distributor Ground Lead Wires is to ensure proper grounding of the distributor to prevent any electrical interference, which can lead to poor engine performance and damage to the ignition system.

How can I determine if my Distributor Ground Lead Wires are faulty?

You can determine if your Distributor Ground Lead Wires are faulty by checking for symptoms such as misfiring, rough idle, and poor acceleration. A multimeter can also be used to check for continuity and resistance in the wires.

Can a faulty Distributor Ground Lead Wire cause damage to other components in the ignition system?

Yes, a faulty Distributor Ground Lead Wire can cause damage to other components in the ignition system due to the increased voltage levels caused by the lack of proper grounding.

How often should I inspect my Distributor Ground Lead Wires?

It is recommended to inspect your Distributor Ground Lead Wires every time you perform a tune-up or replace the spark plugs.

How do I replace my Distributor Ground Lead Wires?

To replace your Distributor Ground Lead Wires, you will need to follow these steps:

  1. Disconnect the negative battery cable.
  2. Locate the distributor cap and remove it.
  3. Identify the distributor ground lead wire and disconnect it from the distributor.
  4. Remove the old distributor ground lead wire and install the new one.
  5. Reconnect the distributor ground lead wire to the distributor.
  6. Reinstall the distributor cap.
  7. Reconnect the negative battery cable.


What are some tips for maintaining my Distributor Ground Lead Wires?

Here are some tips for maintaining your Distributor Ground Lead Wires:

  1. Keep the wires clean and free of corrosion.
  2. Check the wires for any signs of wear or damage.
  3. Replace the wires if they are damaged or worn out.
  4. Make sure the wires are properly connected and secured to the distributor and the ground source.