HVAC Recirculation Door Actuators

Replacement Parts > HVAC > Heater Control Valve and Related Components

HVAC Recirculation Door Actuators

Filter Options

Important: To get started, click the blue "Filter Options" button to select your vehicle and then use the filters to narrow your options.

Important: To get started, select your vehicle on the left and then use the filters to narrow your options.

What is an HVAC Recirculation Door Actuator?

An HVAC Recirculation Door Actuator is an electrical component that is responsible for controlling the air flow of the climate control system in vehicles. It is usually found in the center of the dash and is connected to a cable or an electrical wire.

What is the purpose of an HVAC Recirculation Door Actuator?

The purpose of an HVAC Recirculation Door Actuator is to control the air flow of the climate control system by moving the recirculation door. This door helps to control the temperature of the cabin and the flow of air from inside the cabin to outside the cabin.

How can I determine if my HVAC Recirculation Door Actuator is faulty?

If your HVAC Recirculation Door Actuator is faulty, you may notice the following symptoms:

  1. A decrease in the air flow coming from the vents.
  2. An increase in the temperature of the cabin.
  3. An unexpected increase or decrease in the air flow coming from the vents.


Can a faulty HVAC Recirculation Door Actuator cause damage?

Yes, a faulty HVAC Recirculation Door Actuator can cause damage to your vehicle. If the air flow is not properly regulated, it can cause your vehicle to overheat or suffer from other issues related to the climate control system.

How do I replace an HVAC Recirculation Door Actuator?

Replacing an HVAC Recirculation Door Actuator is a relatively straightforward process. Here are the steps you should take:

  1. Disconnect the negative terminal of the battery.
  2. Disconnect any electrical components connected to the actuator.
  3. Remove the mounting screws and remove the actuator.
  4. Install the new actuator and reconnect all electrical components.
  5. Reconnect the negative terminal of the battery.