What is a rocker panel molding?

A rocker panel molding is a strip of plastic or metal that runs along the sides of a car or truck to cover the gap between the rocker panel and the wheel well. They are used to improve the appearance of the vehicle and protect the paint from chips and scratches.

What is the purpose of a rocker panel molding?

The primary purpose of a rocker panel molding is to protect the paint on the vehicle and improve its aesthetic appearance. It also helps to reduce the amount of dirt, debris and water that can enter the rocker panel and cause rust or corrosion.

How do I know if my rocker panel molding is faulty?

You should inspect your rocker panel molding periodically for signs of wear and tear, such as cracks, scratches, or missing pieces. If you notice any of these issues, it's best to replace the molding as soon as possible.

Can a faulty rocker panel molding cause damage?

Yes, a faulty rocker panel molding can cause damage to the paint on the vehicle, as well as rust or corrosion to the rocker panel if dirt and water are allowed to enter.

How do I replace a rocker panel molding?

Replacing a rocker panel molding is relatively easy and can be done with basic tools. To replace a rocker panel molding, follow these steps:

1. Remove the old molding by gently prying it off with a flat-head screwdriver.
2. Clean the area where the old molding was located with a rag and rubbing alcohol to remove any dirt or debris.
3. Place the new molding in the desired location and use a rubber mallet to gently tap it into place.
4. Secure the new molding with plastic screws or clips, if applicable.