ADVICS A6R1064 Disc Brake Rotor - Rear

ADVICS Rear Disc Brake Rotor for Camry

The ADVICS A6R1064 is a rear disc brake rotor built for 2018-2024 Toyota Camry applications. It uses a high carbon, full cast construction with a smooth, non-directional braking surface to support consistent contact and efficient airflow.

As part of the ADVICS Original Equipment Manufacturer line, this rotor reflects OE-focused engineering for drivers looking for a direct-fit rear brake rotor for Toyota Camry models.

Key Features

• Fits 2018-2024 Toyota Camry, rear
• Part number A6R1064
• High carbon rotor material for thermal stability
• Full cast construction with a solid rotor design
• Non-directional disc finish and smooth surface type
• Coated hat finish with rust-resistant coating
• Premium grade rotor built to OE specifications
• 5-bolt mounting pattern with 114.3 mm bolt circle

Product Details

The ADVICS A6R1064 rear brake rotor is engineered with a 281 mm outside diameter, 193 mm inside diameter, 52.7 mm overall height, and 62 mm center hole diameter. It features a nominal thickness of 10 mm and a discard thickness of 8.5 mm, giving you the dimensional details needed when comparing replacement brake rotors for a Toyota Camry rear brake service.

This rotor is a drum-in-hat style design with a coated hat finish and rust-resistant coating to help maintain appearance and serviceability. The non-directional brake surface supports even pad contact, while the solid rotor construction is suited to rear brake applications where OE-style fit and finish matter. This part cross-references Raybestos Brakes (e.g., 982285) for the same application.

Common Reasons to Replace

• Rear brake pulsation or vibration during braking
• Rotor scoring, grooves, or uneven wear
• Corrosion on the braking surface or hat area
• Brake noise caused by worn or heat-affected rotors
• Reduced braking consistency on a Toyota Camry rear axle

Installation Notes

Confirm rotor dimensions, bolt pattern, and rear position before installation. Clean the hub mounting surface thoroughly so the rotor seats flat, and inspect pads, caliper hardware, and wheel bearings during brake service. For best results, follow the vehicle manufacturer’s brake service procedures and torque specifications.

Quality Assurance

ADVICS Original Equipment Manufacturer brake components are built to OE-level specifications for fit, finish, and performance consistency. The A6R1064 is manufactured to support proper airflow and dependable rear brake operation on the Toyota Camry platform.