ATE 230008 Disc Brake Caliper - Rear Right

ATE Rear Right Disc Brake Caliper

The ATE Disc Brake Fixed Caliper, part number 230008, is a rear right brake caliper built for Mercedes-Benz applications that require a fixed caliper design. It is engineered with ATE’s focus on material selection, endurance testing, and simulation-based validation before release.

ATE Disc Brake Fixed Caliper 230008 is a direct-fit brake hydraulics component for select Mercedes-Benz CLK, E-Class, SL, and AMG models. If you are replacing a worn rear right caliper on a Mercedes-Benz E320, CLK320, or SL500, this part number 230008 provides the correct fixed-caliper configuration for the listed vehicles.

Key Features

• Fixed disc brake caliper design
• Rear right position
• Pads included: No
• Built for brake hydraulics service and caliper replacement
• ATE product line focused on fixed and floating calipers in aluminum and nodular cast iron
• Part number 230008 for identification and ordering

Product Details

ATE Disc Brake Fixed Caliper 230008 is part of ATE’s disc brake caliper line, which emphasizes tested materials and validated performance under demanding conditions. This caliper is intended for Mercedes-Benz rear brake service where the original equipment configuration calls for a fixed caliper. It cross-references ATE 8AC 355 382-041 and 0014203683 for the same application.

Compatible With select Mercedes-Benz CLK320, CLK430, E300, E320, E420, E430, C36 AMG, SL320, and SL500 rear right applications. Confirm the vehicle’s brake setup and notes before ordering, especially on models with retaining-pin or chassis-number-specific requirements.

Common Replacement Reasons

• Brake fluid leakage at the caliper body or piston area
• Uneven rear braking or pulling during stops
• Sticking or seized caliper movement
• Corrosion or wear on the original rear right caliper
• Brake drag after pad and rotor service

Installation Notes

Verify rear right fitment against the vehicle’s year, model, and notes before installation. Some listed Mercedes-Benz applications require 2 retaining pins or chassis-number-specific confirmation. Inspect brake hoses, pads, and rotors during caliper replacement, and bleed the hydraulic system after installation according to factory service procedures.

Quality Assurance

ATE subjects calipers to endurance testing and simulation before approving them for its range. The brand’s brake caliper program is built around validated materials and established brake technology for European vehicle applications.