ATE SP12152 Disc Brake Rotor - Rear

ATE Coated Rear Brake Rotor for BMW X5

The ATE Coated Single Pack Rotor SP12152 is a rear disc brake rotor built for 2000-2006 BMW X5 applications. It uses a full cast metal construction with a non-directional finish and a rust-resistant coating to support consistent braking performance and corrosion protection.

ATE, the brake brand of Continental Automotive Systems, applies OE-focused engineering and premium materials to its aftermarket brake parts. The ATE Coated Single Pack Rotor line carries that approach into coated brake discs for drivers who want a direct-fit replacement for the BMW X5 rear brake rotor application.

Key Features

• Part number SP12152
• Rear disc brake rotor for 2000-2006 BMW X5
• Full cast metal construction
• Solid rotor design
• Non-directional disc finish
• Rust-resistant coating for added corrosion protection
• 324.00 mm outside diameter
• 12.00 mm nominal thickness
• 5-bolt hole pattern
• 3.515 in. height

Detailed Description

ATE SP12152 is a coated rear brake rotor engineered for BMW X5 rear brake service from 2000 through 2006. The solid rotor design, 324.00 mm outside diameter, and 12.00 mm nominal thickness align with the listed fitment and support stable brake contact under normal road use. The non-directional finish helps simplify rotor preparation during service, while the rust-resistant coating helps protect exposed surfaces from corrosion.

This ATE Coated Single Pack Rotor is part of ATE’s coated brake disc program, which focuses on OE-style engineering, first-quality materials, and consistent manufacturing standards. For shoppers searching for a rear brake rotor for BMW X5 2000-2006 or an ATE SP12152 replacement rotor, this part matches the confirmed rear fitment listed here.

This part cross-references Bosch 15010070 and Brembo 08.7019.81 for the same application.

What It Helps Address

• Rear brake rotor wear and reduced braking surface thickness
• Brake pulsation caused by rotor surface irregularity
• Corrosion on exposed rotor surfaces
• Noise related to worn or uneven rear rotors
• Service replacement needs for BMW X5 rear brake maintenance

Installation Notes and Tips

Verify rotor dimensions, bolt pattern, and rear position before installation. Clean the hub mounting surface thoroughly to help prevent runout concerns and uneven rotor seating. Inspect pads, caliper hardware, and wheel bearings during brake service so the new rotor can perform as intended. Confirm the rotor is installed on the rear axle only for the listed BMW X5 applications.

Quality Assurance

ATE brake parts are backed by Continental Automotive Systems’ OE brake system experience and are produced to a higher standard than conventional replacement parts. The coated rotor design reflects ATE’s focus on premium materials and process engineering for aftermarket brake service.