ATE SP22163 Disc Brake Rotor - Rear

ATE Coated Rear Brake Rotor

The ATE Coated Single Pack Rotor SP22163 is a vented disc brake rotor built for rear axle applications that demand consistent braking performance and corrosion protection. With a rust-resistant coating, full cast construction, and non-directional finish, it is engineered for clean installation and dependable service on select Audi and Volkswagen models.

Key Features

• Part number: SP22163
• Rear disc brake rotor for select applications
• Vented rotor design
• Full cast metal construction
• Rust resistant coating for added surface protection
• Non-directional disc finish
• Outside diameter: 256.00 mm
• Nominal thickness: 22.00 mm
• Bolt hole diameter: 5
• Height: 2.271 in

Product Details

ATE Coated Single Pack Rotor SP22163 is part of the ATE brake disc line, which focuses on coated rotors made with premium materials and precise manufacturing standards. ATE is the Continental Automotive Systems brake brand, drawing on original equipment experience across major vehicle platforms. This rotor is a direct rear brake rotor application for 2001-2006 Audi TT Quattro, 2002-2005 Volkswagen Golf, 2003-2005 Volkswagen Jetta, and 2004 Volkswagen R32. The SP22163 part number is also referenced in cross applications such as Brembo 09.A652.1X and Raybestos Brakes 980131.

Common Issues This Rotor Addresses

• Rear brake pulsation from worn rotor surfaces
• Brake noise caused by uneven rotor wear
• Corrosion on exposed rotor surfaces
• Reduced braking consistency from rotor thickness loss
• Service replacement needs for Audi TT Quattro and Volkswagen rear brake systems

Installation Notes and Tips

Verify rotor diameter, thickness, and rear-position fitment before installation. This rotor is specified for 256 mm rear applications on the listed Audi and Volkswagen models. Inspect pads, calipers, and hub surfaces during service, and follow vehicle manufacturer torque and bedding procedures after installation. Confirm the part number SP22163 against the vehicle’s brake system requirements before ordering.

Quality Assurance

ATE brake parts are produced to a higher standard than conventional aftermarket replacements, using engineering input from Continental Automotive Systems and experience gained from OE brake system supply. The coated rotor design helps protect the braking surface during storage and service, while supporting consistent fit and finish for the listed applications.