BBB Industries 97-01335A Disc Brake Caliper - Front Right

Front Right Reman Brake Caliper for Subaru Impreza

BBB Industries 97-01335A is a remanufactured disc brake caliper for the front right position on select 2006-2007 Subaru Impreza models. It features a cast iron housing, steel piston construction, a gray rust-preventative finish, and a bleeder screw already installed for service-ready replacement.

Key Features

• Fits 2006-2007 Subaru Impreza, front right
• Remanufactured disc brake caliper from BBB Industries
• Cast iron body with steel piston and dust boots
• Banjo bolt inlet fitting and M10-1.0 inlet thread
• Bleeder screw included; M7-1.0 x 32 size
• Gray caliper finish with rust preventative coating
• Brake pad installation hardware included where applicable
• Part number 97-01335A for accurate ordering and lookup

Detailed Description

BBB Industries 97-01335A is a reman caliper w/ installation hardware product line replacement built for the front right brake corner on the 2006-2007 Subaru Impreza. The remanufactured design restores hydraulic braking function with a 40 mm piston, four-piston configuration, and durable cast iron housing. The gray finish and rust preventative coating help protect the caliper body during everyday use, while the included dust boots support proper sealing around moving components. This part number, 97-01335A, is a direct fitment-focused choice for Subaru Impreza brake service when replacing a worn or sticking front right caliper.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Can Address

• Uneven front brake pad wear on the right side
• Brake drag caused by a sticking caliper piston
• Reduced braking response from a leaking or worn hydraulic caliper
• Corrosion on the original front right caliper housing
• Noise or vibration related to caliper wear or seizure

Installation Notes and Tips

Verify the vehicle is a 2006-2007 Subaru Impreza with front right caliper application before installation. Confirm the banjo bolt connection, M10-1.0 inlet thread, and M7-1.0 bleeder screw size match the existing brake line and service hardware. Brake pad installation hardware is included where applicable, but pads are not included. Always bleed the brake system after caliper replacement and inspect the rotor, pads, and brake hose condition during service.

Quality Assurance

BBB Industries remanufactures brake components to restore proper fit and function for service replacement. Part number 97-01335A is built as a remanufactured caliper for the specified Subaru Impreza front right application, with hardware and sealing components included as listed in the product data.