BBB Industries 97-09123A Disc Brake Caliper - Rear Right

Rear Right Remanufactured Brake Caliper

BBB Industries 97-09123A is a remanufactured disc brake caliper for the rear right position on select Saab applications. It is built with a cast iron housing, steel pistons, a gray rust-preventative finish, and a bleeder screw for serviceable brake system maintenance.

Compatible with 1997-1998 Saab 900 and 1999-2003 Saab 9-3 rear right brake applications, this BBB Industries reman caliper w/ installation hardware line is focused on direct-fit brake hydraulics service. Part number 97-09123A is a practical replacement when the original caliper shows wear, leakage, or uneven braking performance.

Key Features

• Remanufactured disc brake caliper for rear right installation
• Cast iron caliper body with steel piston construction
• Gray finish with rust preventative coating
• Bleeder screw included; M7-1.0 x 39 size
• M10-1.0 inlet port thread size with plug-style inlet fitting
• Dust boots included for caliper sealing protection
• Two 35 mm pistons for hydraulic braking force
• Brake pad installation hardware included where applicable

Product Details

The BBB Industries Reman Caliper w/ Installation Hardware product line is built for brake hydraulic replacement service where a remanufactured caliper is preferred over a new casting. This 97-09123A unit uses a cast iron housing and steel pistons, with a rust preventative finish to support long-term service in demanding brake environments. The caliper is configured for the rear right position and uses a 35 mm dual-piston design.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application. Use BBB Industries 97-09123A when servicing Saab 900 rear right brake caliper applications from 1997-1998 or Saab 9-3 rear right brake caliper applications from 1999-2003.

Common Brake Issues This Caliper Addresses

• Brake fluid leakage from a worn caliper body or piston seal area
• Uneven rear braking caused by sticking or corroded caliper components
• Poor pedal response related to caliper hydraulic wear
• Brake drag from seized piston movement
• Service issues tied to damaged bleeder hardware or deteriorated dust boots

Installation Notes

Verify rear right position fitment before installation. Confirm inlet thread size, bleeder screw size, and brake line connection style match the vehicle’s original hardware. Transfer or replace pads as needed, and bleed the brake system thoroughly after installation to remove air from the hydraulic circuit. Inspect the rotor, pads, and brake hose condition before returning the vehicle to service.

Fits 1997-1998 Saab 900, rear right. Fits 1999-2003 Saab 9-3, rear right.

Quality Assurance

BBB Industries remanufactured brake components are processed for brake service applications with attention to fit, function, and corrosion-resistant finishing. Part number 97-09123A is built as a remanufactured replacement caliper for the specified Saab rear right applications.