BBB Industries 97-17630A Disc Brake Caliper - Front Right

Front Right Disc Brake Caliper for Chrysler and Dodge

BBB Industries 97-17630A is a remanufactured front right disc brake caliper for select Chrysler and Dodge applications. It is built with a cast iron housing, a steel piston, and a gray rust-preventative finish for service replacement on vehicles such as the Chrysler Fifth Avenue, Town & Country, Imperial, New Yorker, LeBaron, and Dodge Aspen.

Key Features

• Remanufactured disc brake caliper for front right placement
• Cast iron body with steel piston for hydraulic brake service
• Gray caliper finish with rust preventative coating
• Banjo bolt inlet fitting and 7/16-20 inlet port thread size
• Bleeder screw included; dust boots included
• Brake pad installation hardware included where applicable
• Single-piston design with 70 mm piston diameter
• Compatible with housing cast numbers 4126 and 643

Product Details

The BBB Industries Reman Caliper w/ Installation Hardware line focuses on remanufactured brake hydraulics built for direct replacement service. Part number 97-17630A is a front right disc brake caliper with a 3/8-24 bleeder screw, banjo bolt inlet, and a cast iron housing finished for corrosion resistance. This caliper is listed for 1983-1989 Chrysler Fifth Avenue, 1983-1986 Chrysler Town & Country, 1980-1981 Chrysler Town & Country, 1981-1983 Chrysler Imperial, 1982 Chrysler New Yorker, 1980-1981 Chrysler LeBaron, and 1980 Dodge Aspen. If you are sourcing a reman brake caliper for a Chrysler Fifth Avenue front right or a Chrysler Town & Country front right application, 97-17630A matches the specified fitment.

Common Repair Uses

• Restores hydraulic braking performance when the original caliper is sticking or seized
• Addresses uneven front brake wear on the right side
• Replaces a leaking caliper housing or damaged piston seal area
• Corrects soft or inconsistent brake pedal response caused by caliper wear
• Replaces a corroded front right caliper on older Chrysler and Dodge vehicles

Installation Notes

Verify front right fitment, inlet thread size, and banjo bolt connection before installation. Transfer or replace brake pads as needed, and inspect brake hoses, rotors, and mounting points for wear or damage. Bleed the brake system thoroughly after installation to remove air from the hydraulic circuit. Confirm that the caliper matches the vehicle’s original housing cast numbers and brake hardware layout before final assembly.

Quality Assurance

BBB Industries remanufactured brake components are processed for replacement use in hydraulic brake systems and inspected to meet application-specific fitment requirements. Part number 97-17630A is built as a remanufactured caliper for the listed Chrysler and Dodge front right applications.