BBB Industries 97-17846A Disc Brake Caliper - Front Right

Remanufactured Front Right Brake Caliper

BBB Industries 97-17846A is a remanufactured disc brake caliper for the front right position on select Ford full-size vans and trucks. It is built with a cast iron housing, gray rust-preventative finish, and a 55 mm aluminum piston for direct hydraulic braking performance.

The BBB Industries Reman Caliper w/ Installation Hardware line focuses on remanufactured brake hydraulics with the core service parts needed for a proper caliper replacement. This 97-17846A caliper includes a bleeder screw and brake pad installation hardware, along with a banjo bolt and copper crush washers where applicable.

Key Features

• Remanufactured disc brake caliper for the front right side
• Cast iron housing with rust-preventative gray finish
• 55 mm aluminum piston with dual-piston design
• Banjo bolt inlet fitting with 3/8-24 inlet thread
• Bleeder screw included; dust boots included
• Brake pad installation hardware included where applicable
• Pad set, anti-squeal shims, and wear sensors not included

Detailed Description

BBB Industries 97-17846A is a remanufactured front right disc brake caliper engineered for Ford E-250 Econoline, E-250 Econoline Club Wagon, E-350 Econoline, E-350 Econoline Club Wagon, F-250, and F-350 applications from 1980-1985. It uses a 2-inch, 55 mm piston arrangement and a banjo bolt inlet connection with 3/8-24 threading for the hydraulic line connection. The gray finish and dust boots help protect the caliper housing in service, while the cast iron body supports stable brake operation.

For buyers searching for a 1980-1985 Ford F-250 front right brake caliper, a Ford E-350 Econoline front right reman caliper, or a BBB Industries 97-17846A replacement caliper, this part matches the listed vehicle applications and position. It is a direct-fit hydraulic caliper replacement for the specified Ford models and years.

Common Problems This Part Can Address

• Brake fluid leakage at the caliper body or piston area
• Uneven braking caused by a sticking or seized caliper
• Poor pedal response from a worn hydraulic caliper assembly
• Corrosion on the original caliper housing
• Brake drag or pull at the front right wheel

Installation Notes and Tips

Confirm the front right position, banjo bolt connection, and 3/8-24 inlet thread before installation. Inspect the brake hose, copper crush washers, pads, and rotor condition during service, and bleed the brake system after installation to remove air from the hydraulic circuit. Verify caliper casting numbers 390 or AA when matching an original unit.

Quality Assurance

BBB Industries remanufactured brake components are rebuilt to restore serviceable hydraulic function for listed applications. This part number is 97-17846A.