BBB Industries 97B03114B Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for Porsche Boxster and Cayman

BBB Industries 97B03114B is a remanufactured rear right disc brake caliper for select Porsche Boxster and Cayman applications with iron discs. It features a black powder-coated aluminum housing, four aluminum pistons, and included bleeder screw and dust boots for a direct brake service replacement.

Key Features

• Remanufactured disc brake caliper with installation hardware
• Black powder coat finish for a clean OE-style appearance
• Aluminum casting and aluminum piston material
• Four-piston design with 28 mm and 30 mm piston diameters
• Bleeder screw included; M10-1.0 inlet and bleeder thread size
• Dust boots included for added protection
• Package contents include brake pad installation hardware with banjo bolt and copper crush washers where applicable
• Compatible with rear right Porsche Boxster and Porsche Cayman brake service applications

Product Details

This BBB Industries reman caliper w/ installation hardware is built for rear right brake replacement on Porsche Boxster and Porsche Cayman models listed below. The aluminum housing and powder-coated black finish support a clean installation, while the four-piston layout helps restore proper hydraulic clamping at the wheel. Part number 97B03114B is a practical choice when servicing a worn, sticking, or leaking rear caliper on a Porsche Boxster or Cayman with iron disc brakes.

BBB Industries 97B03114B is listed for Fits 2013-2016 Porsche Boxster, rear right; Fits 2014 Porsche Cayman, rear right; Fits 1997-2012 Porsche Boxster, rear right; and Fits 2007-2012 Porsche Cayman, rear right. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Brake drag caused by a sticking rear caliper
• Fluid leakage from a worn caliper housing or seal area
• Uneven rear braking performance
• Corrosion or finish damage on the original caliper
• Reduced braking response from a failing hydraulic caliper assembly

Installation Notes

Verify rear right position, iron disc brake setup, and M10-1.0 inlet thread before installation. Transfer or replace brake pads as needed, and confirm banjo bolt and copper crush washer requirements for your specific application. Bleeding the brake system after installation is required to remove air from the hydraulic circuit.

Quality Assurance

BBB Industries remanufactures brake components to restore serviceable performance for repair applications. This caliper is remanufactured and supplied with the listed hardware and seals shown in the product data.