BBB Industries 99-01244A Disc Brake Caliper - Rear Right

Rear Right Reman Caliper for Montero

BBB Industries 99-01244A is a remanufactured disc brake caliper for the rear right position on select Mitsubishi Montero applications. It is built with a cast iron housing, steel piston, gray finish, and rust preventative coating for service-ready brake system replacement.

This BBB Industries Reman Caliper w/ Installation Hardware line focuses on remanufactured brake hydraulics with the mounting bracket and service hardware needed for the listed application. For Mitsubishi Montero rear brake service, 99-01244A provides the correct caliper configuration with a 45 mm piston and banjo bolt inlet connection.

Key Features

• Remanufactured disc brake caliper for rear right installation
• Cast iron housing with steel piston for hydraulic brake service
• Gray caliper finish with rust preventative coating
• Includes caliper slides, dust boots, bleeder screw, bracket, and hardware
• Banjo bolt inlet fitting with M10-1.0 inlet thread size
• 45 mm piston diameter for the specified rear brake application
• Fits 2000 Mitsubishi Montero, rear right, from 02/00
• Fits 2001-2006 Mitsubishi Montero, rear right

Detailed Description

BBB Industries 99-01244A is a reman caliper for the rear right side of the Mitsubishi Montero, engineered for vehicles listed from 2000 through 2006. It uses a single 45 mm steel piston, cast iron construction, and a banjo bolt inlet fitting, with a bleeder screw and dust boots included for brake hydraulic service. The bracket is included, and the caliper is identified by housing and bracket cast number 4501.

For buyers searching for a rear right Mitsubishi Montero brake caliper, 99-01244A is the direct application-specific part number to verify against the vehicle year and build date. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Repair Uses

• Restoring rear brake hydraulic pressure after caliper wear or seizure
• Replacing a leaking or sticking rear right caliper on a Mitsubishi Montero
• Correcting uneven rear brake pad wear caused by caliper drag
• Addressing brake fluid seepage at the bleeder screw or inlet connection
• Replacing a corroded rear caliper assembly during brake service

Installation Notes

Verify rear right fitment before ordering, especially on 2000 Mitsubishi Montero vehicles built from 02/00 and 2001-2006 Mitsubishi Montero models. Confirm the banjo bolt connection, M10-1.0 inlet thread size, and bracket configuration match the original unit. Brake pad installation hardware is listed in the package contents where applicable, but pads are not included.

Use proper brake bleeding procedures after installation and inspect the brake hose, copper crush washers, and mounting surfaces before assembly. The caliper includes a bleeder screw with M7-1.0 thread size and is intended for direct replacement on the specified rear right Montero application.

Quality Assurance

BBB Industries remanufactured brake hydraulics are built to match the listed application details, including piston size, inlet style, and bracket configuration. Part number 99-01244A is specified for the rear right Mitsubishi Montero brake system shown in the fitment data.