BBB Industries 99-02147A Disc Brake Caliper - Rear Right

Rear Right Reman Brake Caliper for Audi A4

BBB Industries 99-02147A is a remanufactured disc brake caliper for the rear right position on select Audi A4 and Audi A4 Quattro models. It is built with a cast iron housing, steel piston, gray finish, and rust preventative coating for a service-ready replacement.

The BBB Industries Reman Caliper w/ Installation Hardware line focuses on remanufactured brake hydraulics with application-specific fitment and included service components where applicable. Part number 99-02147A follows that approach with a bracket, bleeder screw, dust boots, caliper slides, and brake pad installation hardware w/ banjo bolt and copper crush washers where applicable.

Key Features

• Remanufactured disc brake caliper for rear right installation
• Fits 2005-2006 Audi A4, rear right, with mounting bracket for use with 288mm disc
• Fits 2005-2006 Audi A4 Quattro, rear right, with mounting bracket for use with 288mm disc
• Fits 2007-2009 Audi A4, rear right
• Fits 2007-2009 Audi A4 Quattro, rear right
• Cast iron housing with steel piston and gray rust preventative finish
• Includes caliper slides, dust boots, bracket, and bleeder screw
• Banjo bolt inlet fitting with M12-1.0 inlet thread and M10-1.0 bleeder thread
• 41 mm single-piston design

Detailed Description

BBB Industries 99-02147A is a reman brake caliper engineered for rear right brake service on select Audi A4 and Audi A4 Quattro vehicles from 2005 through 2009. This disc brake caliper uses a single 41 mm steel piston inside a cast iron body, with a rust preventative finish to support long-term brake system service. The bracket is included, and the unit is configured with a banjo bolt inlet and M12-1.0 inlet thread for the specified applications. For 2005-2006 Audi A4 and Audi A4 Quattro models, the caliper is supplied with a mounting bracket for use with a 288mm disc. Part number 99-02147A is a direct-fit brake hydraulics replacement for the listed rear right applications.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Problems This Part Can Address

• Rear brake drag caused by a sticking caliper piston
• Uneven rear brake pad wear on the right side
• Brake fluid leakage at the caliper body or bleeder area
• Corrosion-related caliper seizure on older Audi A4 brake systems
• Reduced braking response from a worn reman brake caliper assembly

Installation Notes and Tips

Verify rear right fitment against your vehicle before purchase, especially on 2007-2009 Audi A4 and Audi A4 Quattro applications. Confirm the brake disc size and bracket requirements for 2005-2006 models using a 288mm disc. Inspect brake hoses, pads, and mounting points during installation, and bleed the hydraulic system after caliper replacement to remove air from the circuit.

Quality Assurance

BBB Industries remanufactures brake hydraulics to meet application-specific replacement needs for import vehicles such as the Audi A4 and Audi A4 Quattro. Part number 99-02147A is built as a remanufactured caliper with the listed hardware and component details for the confirmed fitment range.