BBB Industries 99-07608B Disc Brake Caliper - Front Left

Remanufactured Front Left Caliper for Mitsubishi and Dodge

BBB Industries 99-07608B is a remanufactured disc brake caliper for the front left position on select Mitsubishi Mighty Max, Dodge Ram 50, and Mitsubishi Van applications. It is built with a cast iron housing, steel piston, gray rust-preventative finish, and included caliper slides and bracket for a direct brake service replacement.

Key Features

• Remanufactured disc brake caliper with installation hardware details listed in the package contents
• Front left fitment for 1987-1996 Mitsubishi Mighty Max, 1987-1993 Dodge Ram 50, and 1987-1990 Mitsubishi Van
• Cast iron construction with a steel piston for brake hydraulic durability
• Gray caliper finish with rust preventative coating
• Includes caliper slides, bracket, dust boots, and bleeder screw
• 57 mm piston diameter with M10-1.0 inlet and bleeder thread size
• Brake pad installation hardware, banjo bolt, and copper crush washers included where applicable

Product Details

BBB Industries 99-07608B is part of the Reman Caliper w/ Installation Hardware line, a brake hydraulics solution focused on remanufactured calipers prepared for service replacement. This unit uses a single 57 mm steel piston, cast iron housing, and tube seat inlet fitting, with a bracket cast number of 2211 and housing cast numbers 2211 and L. The caliper is finished in gray with a rust preventative coating and includes a bleeder screw sized M10-1.0 x 33.

For buyers searching for a front left brake caliper for Mitsubishi Mighty Max, Dodge Ram 50, or Mitsubishi Van, part number 99-07608B provides the specified hydraulic and mounting configuration for the listed applications. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Brake Issues This Part Can Address

• Leaking caliper housing or damaged piston seals
• Uneven braking from a sticking front left caliper
• Corrosion on the original caliper body or piston area
• Brake drag caused by worn slides or internal caliper wear
• Loss of braking performance from a failed hydraulic caliper assembly

Installation Notes

Verify bracket casting numbers, inlet thread size, and front left position before installation. Prior to purchase, ensure compatibility of this disc brake caliper bracket with your vehicle. Transfer or replace brake pads as needed, and bleed the brake system after installation to remove air from the hydraulic circuit. Confirm banjo bolt and copper crush washer application where applicable during assembly.

Quality Assurance

BBB Industries remanufactures brake components to service replacement standards, with this caliper prepared for direct use in the listed applications. The remanufactured design, rust preventative finish, dust boots, and included bleeder screw support a complete brake service installation.