BBB Industries 99-17981A Disc Brake Caliper - Rear Right

Rear Right Brake Caliper for Ford F-150

BBB Industries 99-17981A is a remanufactured rear right disc brake caliper for select Ford F-150 applications with a manual parking brake. It is supplied with a mounting bracket and installation hardware details specified for the application, making it a direct replacement option for brake hydraulic service.

Key Features

• Remanufactured disc brake caliper from BBB Industries
• Rear right position for select Ford F-150 models
• Cast iron housing with gray rust preventative finish
• 54 mm phenolic piston for brake actuation
• Includes caliper slides, dust boots, bleeder screw, bracket, and hardware
• Banjo bolt inlet fitting with M10-1.0 thread size
• Brake pad installation hardware, banjo bolt, and copper crush washers included where applicable

Product Details

The BBB Industries Reman Caliper w/ Installation Hardware line is built for brake hydraulic replacement work where a remanufactured caliper is preferred over a new casting. Part number 99-17981A uses a cast iron body, phenolic piston, and rust preventative finish to match the requirements of rear disc brake service on the Ford F-150. The caliper includes a bleeder screw, dust boots, caliper slides, and bracket for the specified application.

Compatible With 2015-2017 Ford F-150, rear right, and 2019-2020 Ford F-150, rear right. It also covers 2012-2014 Ford F-150, rear right, with a note to verify bracket compatibility before purchase. BBB Industries 99-17981A is a fitment-specific brake caliper for vehicles equipped with a manual parking brake.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Repair Uses

• Restores rear brake clamping force on a worn or sticking caliper
• Addresses uneven rear brake pad wear on the Ford F-150
• Replaces a leaking caliper with damaged seals or dust boots
• Corrects parking brake-related rear brake service issues on manual parking brake setups
• Supports brake pedal feel recovery after hydraulic caliper failure

Installation Notes

Verify rear right fitment, bracket configuration, and manual parking brake setup before installation. The inlet fitting uses a banjo bolt connection with M10-1.0 thread sizing, and the bleeder screw is M10-1.0 x 28. Inspect brake hoses, pads, and rotor condition during caliper replacement. Follow proper bleeding procedures after installation to remove air from the hydraulic system.

Quality Assurance

BBB Industries remanufactures brake components to service replacement standards for hydraulic brake repair. Part number 99-17981A is built as a remanufactured caliper assembly for the listed Ford F-150 applications.