Beck Arnley 083-3731 Disc Brake Rotor - Front

Front Vented Brake Rotor for Toyota C-HR

Beck Arnley 083-3731 is a front disc brake rotor built to match foreign nameplate OE specifications for form, fit, and function. It is a vented rotor with a 5-lug pattern and the dimensions needed for select Toyota C-HR applications, including premium front brake service.

Key Features

• Front disc brake rotor for select Toyota C-HR models
• Vented design for front brake applications
• 5-lug configuration with 114 mm bolt pattern
• Rotor outside diameter: 298 mm
• Rotor minimum thickness: 25 mm
• Rotor center hole I.D.: 62 mm
• Rotor height: 49 mm
• Rotor hub O.D.: 166 mm
• Rotor ID: 155 mm
• Rotor surface thickness: 28 mm
• Lug stud hole I.D.: 14.7 mm

Detailed Description

Beck Arnley 083-3731 is engineered for front brake service on 2018-2022 Toyota C-HR models, with coverage for 2020-2022 Toyota C-HR front applications except Japan-built vehicles and 2018-2019 Toyota C-HR front applications. This rotor follows OE-style dimensional requirements to support proper rotor fitment, wheel mounting alignment, and brake system compatibility on the Toyota C-HR. Beck Arnley sources parts to meet foreign nameplate OE specifications, helping ensure the right replacement for the application. This part number, 083-3731, is a direct fitment-focused choice for front brake rotor replacement on the Toyota C-HR.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Reasons for Replacement

• Brake pulsation or steering wheel shake during braking
• Rotor wear below minimum thickness
• Brake noise caused by uneven rotor surfaces
• Reduced braking consistency from heat-related rotor wear
• Front brake service on a Toyota C-HR with vented rotor requirements

Installation Notes and Tips

Confirm rotor dimensions, bolt pattern, and center bore before installation. Verify front position fitment and check the vehicle build details for 2020-2022 Toyota C-HR models, since Japan-built vehicles are excluded from this application. Inspect pads, caliper hardware, and hub condition during rotor replacement, and measure rotor thickness after installation to confirm it remains above minimum specification. The part number 083-3731 should be matched to the vehicle’s front brake setup before service begins.

Quality Assurance

Beck Arnley parts are sourced to meet foreign nameplate OE specifications for form, fit, and function. That OE-focused approach supports consistent replacement quality for Toyota C-HR front brake service and helps installers select the correct rotor with confidence.