BGMG 10043168 Drive Axle Shaft - Rear Left

Rear Left Drive Axle Shaft for Jeep Wrangler

This FSGR drive axle shaft is built for the rear left position on 2018-2023 Jeep Wrangler models. It is a direct-fit driveline replacement for vehicles showing axle shaft wear, noise, or driveline vibration at the rear axle.

Key Features

• Drive axle shaft for the rear left side
• Fits 2018-2023 Jeep Wrangler applications
• FSGR product line, part number 10043168
• Supports rear driveline torque transfer from the differential to the wheel hub
• Built for axle shaft replacement in driveline and axle service

Detailed Description

Use this drive axle shaft when servicing the rear left axle on a Jeep Wrangler. The part number 10043168 is listed for 2018-2023 Jeep Wrangler, rear left, and is intended for direct replacement in the axle shaft location. For buyers searching for a rear left Jeep Wrangler axle shaft, this FSGR unit provides a fitment-specific solution for driveline repair and restoration.

FSGR is the product line identified for this axle shaft, and part number 10043168 should be matched to the vehicle’s year and rear left position before ordering. This part cross-references no additional part numbers in the provided data.

Common Reasons for Replacement

• Clicking, clunking, or vibration from the rear axle area
• Axle shaft wear from mileage or off-road use
• Damage from impact, corrosion, or seal failure
• Rear wheel drive issues caused by a compromised shaft

Installation Notes and Tips

Confirm the vehicle is a 2018-2023 Jeep Wrangler and verify the rear left position before installation. Inspect related axle seals, bearings, and hub components during service so the replacement axle shaft can be installed into a clean, properly serviced driveline assembly.

Quality Assurance

Fitment is listed specifically for 2018-2023 Jeep Wrangler, rear left. Verify part number 10043168 against the vehicle application and axle position to ensure correct selection.