Bilstein 24-184588 Suspension Shock Absorber - Rear

Bilstein B8 Rear Shock for Corvette

The Bilstein B8 Performance Plus rear shock absorber is built for 1984-1987 Chevrolet Corvette applications with aftermarket lowering springs. It uses a monotube internal design and application-specific valve settings to sharpen handling response while maintaining Bilstein’s OE-level quality standards.

For drivers searching for a 1984-1987 Chevrolet Corvette rear shock absorber or a Bilstein B8 Performance Plus rear damper, part number 24-184588 delivers a direct performance-focused upgrade for lowered suspension setups.

Key Features

• Fits 1984-1987 Chevrolet Corvette, rear
• Bilstein B8 Performance Plus series
• Monotube internal design for consistent damping response
• Application-specific valve settings for lowered vehicles
• Yellow painted finish
• Blue straight boot included
• Lower mount type: eye 16mm
• Upper mount type: eye 12.1mm

Product Details

The Bilstein B8 Performance Plus line is engineered for vehicles running lowering springs, with damping calibration matched to the application rather than a generic tune. On the 1984-1987 Chevrolet Corvette, rear, this shock absorber helps restore control after lowering while supporting more precise body motion and a sportier stance. Part number 24-184588 is part of Bilstein’s performance-oriented B8 lineup and is tested to meet or exceed OE standards.

This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

What It Helps Address

• Excessive rear suspension bounce after lowering springs are installed
• Reduced damping control from worn OE rear shocks
• Loose or unsettled rear-end feel during cornering
• Uneven ride behavior after suspension height changes
• Loss of steering and chassis response in performance driving

Installation Notes and Tips

Verify rear suspension fitment before installation and confirm the eye-to-eye mounting dimensions match the vehicle setup. This shock is intended for use with aftermarket lowering springs, so suspension height and alignment should be checked after installation on the 1984-1987 Chevrolet Corvette. Follow factory service procedures and torque specifications during replacement.

Quality Assurance

Bilstein B8 Performance Plus dampers are rigorously tested and built to meet or exceed OE standards. The monotube construction and application-specific valving reflect Bilstein’s focus on controlled, repeatable damping performance for lowered suspension applications.