Bilstein 35-110743 Suspension Strut Assembly - Front Right

Bilstein B6 Front Right Strut Assembly

The Bilstein B6 Performance strut assembly is a direct performance upgrade for OE-style suspension service, built to work with the factory spring. This front right unit for Mazda 3 and Volvo applications uses a monotube design and application-specific valving to improve handling response and road control.

Part number 35-110743 is engineered for drivers replacing a worn front right suspension strut on select Mazda 3, Volvo C30, Volvo C70, Volvo S40, and Volvo V50 models. Bilstein B6 Performance dampers are tested to meet or exceed OE standards and are finished in Bilstein’s yellow paint.

Key Features

• Bilstein B6 Performance series front right strut assembly
• Monotube internal design for consistent damping response
• Application-specific valve settings matched to OE factory springs
• Lower mount type: bracket
• Upper mount type: stem
• Yellow painted finish
• Boot not included

Product Line Details

The B6 Performance line is Bilstein’s OE-plus damper range for drivers who want firmer control without changing the factory spring setup. This approach keeps the original ride height and spring rate while improving suspension response, steering feel, and overall chassis control. Part number 35-110743 follows that formula for the front right position on supported Mazda and Volvo platforms.

Fitment

• Fits 2004-2013 Mazda 3, front right.
• Fits 2008-2013 Volvo C30, front right.
• Fits 2006-2013 Volvo C70, front right.
• Fits 2004-2011 Volvo S40, front right.
• Fits 2005-2011 Volvo V50, front right.

What This Strut Can Address

• Excessive front-end bounce or poor damping control
• Reduced steering precision during cornering and lane changes
• Uneven ride quality caused by a worn OE strut
• Noisy or unstable suspension behavior at the front right corner
• Loss of composure over bumps and rough pavement

Installation Notes

Install 35-110743 on the front right side only and pair it with the OE factory spring as specified by Bilstein. Verify mount style, position, and vehicle application before installation. Because this is a strut assembly with a stem upper mount and bracket lower mount, confirm the existing suspension layout on the vehicle before ordering.

Quality Assurance

Bilstein rigorously tests B6 Performance dampers to meet or exceed OE standards, with quality control focused on consistent damping performance and durability. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.