Bosch 17362 Oxygen Sensor - Upstream

Bosch 17362 Oxygen Sensor for Volkswagen Jetta

Bosch 17362 is an Actual OE Oxygen Sensor for the upstream position on select Volkswagen Jetta models. It is built for 2013-2016 Volkswagen Jetta applications and supports accurate exhaust feedback for emission control system operation.

Key Features

• Actual OE Oxygen Sensor from Bosch
• Upstream position fitment
• Fits 2013-2016 Volkswagen Jetta, upstream
• Part number 17362 for application matching
• Emission control sensor for exhaust monitoring

Product Details

Bosch Actual OE Oxygen Sensor 17362 is specified for the upstream location on 2013-2016 Volkswagen Jetta models. As an OE-style sensor, it is used to measure exhaust oxygen content before the catalytic converter so the engine management system can monitor air-fuel ratio and emissions performance. If you are searching for a Bosch 17362 oxygen sensor for Volkswagen Jetta upstream fitment, this part matches the listed vehicle coverage.

Common Issues It May Address

• Check engine light related to oxygen sensor performance
• Incorrect air-fuel ratio readings
• Reduced emissions system efficiency
• Fault codes tied to upstream sensor response
• Poor exhaust feedback to the engine control system

Installation Notes

Verify the upstream sensor location before ordering and confirm connector and thread match to the original part. For best results, inspect the exhaust bung and wiring routing during replacement, and clear diagnostic trouble codes after installation if required by the vehicle repair procedure.

Quality Assurance

Bosch Actual OE Oxygen Sensor line focuses on OE-style replacement coverage for factory-matched applications. This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.