Brembo 08.9488.11 Disc Brake Rotor - Rear

Brembo Premium UV Coated Rear Rotor

The Brembo 08.9488.11 is a rear disc brake rotor built as a direct OE-style replacement for select Audi A3, Audi A3 Quattro, Volkswagen Golf, Volkswagen GTI, Volkswagen Jetta, Volkswagen Jetta City, and Volkswagen R32 applications. Its UV-coated surface helps protect exposed areas of the rotor, while the grey cast iron construction supports stable braking performance and everyday driving comfort.

• Premium UV Coated OE equivalent rotor for rear brake service
• Grey cast iron construction for consistent braking performance
• UV-coated rust-resistant surface on braking plate areas
• Solid rotor design with 260 mm outside diameter
• 5-lug pattern with 65 mm centering diameter
• Minimum thickness marking for service reference
• Fixing screws included

Product Line Details

Brembo’s Premium UV Coated OE Equivalent Rotor line is developed as a direct replacement for factory-style brake service. The coating is solvent-free and applied to help protect the rotor surface from corrosion, while the rotor’s construction and dimensions are matched to the listed vehicle applications. Part number 08.9488.11 is also referenced in OE and aftermarket cross listings for the same rear brake application.

Vehicle Fitment

• Fits 2009-2013 Audi A3, rear.
• Fits 2008-2013 Audi A3 Quattro, rear.
• Fits 2010-2011 Volkswagen Golf, rear.
• Fits 2006 Volkswagen Golf, rear.
• Fits 2006-2010 Volkswagen GTI, rear.
• Fits 2010 Volkswagen Jetta, rear; 256 mm diameter.
• Fits 2005-2009 Volkswagen Jetta, rear.
• Fits 2007-2009 Volkswagen Jetta City, rear.
• Fits 2008 Audi A3, rear; from chassis # 8P-8-057 779.
• Fits 2008 Volkswagen R32, rear.

Common Brake Issues This Rotor Addresses

• Rear brake pulsation from worn rotor surfaces
• Corrosion on exposed rotor areas
• Noise and vibration caused by rotor wear
• Reduced braking consistency from rotor thickness loss
• Service fitment concerns on OE-style rear brake replacements

Installation Notes

Verify rotor diameter, centering diameter, and minimum thickness before installation. This rotor is a solid rear design with a nominal thickness of 12 mm and a minimum thickness of 9 mm. The included fixing screws support straightforward installation, and the torque specification is 120 Nm where applicable. For restored braking performance, replace rotors and pads together and pair this rotor with Brembo NAO/Ceramic or Low Met brake pad formulations.

Quality Assurance

Brembo develops this rotor to meet or exceed OEM specifications for the listed applications. The UV coating is intended to provide added surface protection, and the rotor includes intelligent marking for part number and minimum thickness identification. This part cross-references Beck/Arnley 083-2995 and Centric Parts 121.33105 for the same application.