Brembo 09.8485.1X Disc Brake Rotor - Front

Brembo UV Coated Front Rotor

The Brembo Premium Xtra Cross Drilled UV Coated Rotor is a direct replacement disc brake rotor built to meet or exceed OEM specifications. This front rotor uses a high carbon cast iron design where applicable, a drilled braking surface, and a UV-coated finish to help protect exposed surfaces while supporting consistent braking feel.

Fits 2006-2009 Nissan 350Z, front and 2003-2005 Nissan 350Z, front with Brembo brakes. Fits 2003-2004 INFINITI G35, front with Brembo brakes. Part number 09.8485.1X is also listed for the same application.

Key Features

• Part number: 09.8485.1X
• Premium Xtra cross drilled rotor design
• UV-coated rust-resistant surface for added protection
• High carbon material where applicable to help reduce noise and vibration
• Direct replacement rotor for OEM-style fitment
• Drilled braking surface for performance-oriented braking response
• Intelligent marking location shows part number and minimum thickness
• Torque specification: 108 Nm

Product Details

This Brembo rotor is engineered for front axle applications on the Nissan 350Z and INFINITI G35 listed above. The 324 mm outside diameter, 30 mm nominal thickness, 28.6 mm minimum thickness, 5-hole pattern, and 68 mm centering diameter support the specified fitment. Brembo’s UV coating is solvent free and applied to protect the disc, including the braking plate surfaces, while the drilled braking surface supports a performance-focused brake setup. For restoring braking performance, Brembo recommends replacing rotors and pads together. This part cross-references Raybestos Brakes 980250 and Beck/Arnley 083-3013 for the same application.

What It Helps Address

• Brake pulsation from worn or uneven rotor surfaces
• Reduced braking performance from rotor wear below minimum thickness
• Surface corrosion on exposed rotor areas
• Noise and vibration associated with worn brake components
• Brake fade concerns in performance-oriented street driving

Installation Notes

• Verify front axle fitment before installation.
• Inspect pads, calipers, and hub surfaces during rotor replacement.
• Replace rotors and pads together to help restore braking performance.
• Follow the specified torque value of 108 Nm during wheel installation.
• Confirm minimum thickness markings before service.

Quality Assurance

Brembo develops this rotor as an OE-style replacement built to meet or exceed original specifications. The UV-coated finish, high carbon construction where applicable, and clear thickness markings support consistent serviceability and long-term brake system maintenance.