Brembo 09.D027.11 Disc Brake Rotor - Front

Brembo UV Coated Front Rotor for Genesis G70 and Kia Stinger

The Brembo 09.D027.11 is a Premium UV Coated OE Equivalent Disc Brake Rotor built for front axle applications on select Genesis G70 and Kia Stinger models. It uses high carbon cast iron where applicable, a UV-coated rust-resistant surface, and a direct-replacement design to support consistent braking performance and cleaner long-term rotor protection.

Key Features

• Premium UV Coated OE equivalent rotor from Brembo
• High carbon cast iron construction where applicable for reduced noise and vibration
• UV-coated braking surfaces for corrosion resistance
• Solid or vented type rotor: PVT
• Outside diameter: 350 mm
• Nominal thickness: 30 mm; minimum thickness: 28 mm
• Height: 56.6 mm
• Fixing screws included
• Intelligent marking location shows part number and minimum thickness

Product Details

Brembo 09.D027.11 is engineered as a direct replacement rotor that meets or exceeds OEM specifications for the front brake system. The UV coating is solvent-free and protects the disc, including the braking plate surfaces, while the high carbon cast iron design helps improve braking comfort by reducing noise and vibration. For restored braking balance, Brembo recommends replacing rotors and pads together, and pairing this rotor with Brembo NAO/Ceramic or Low Met brake pad formulations.

Compatible with 2022 Genesis G70, front; 2019-2021 Genesis G70, front; 2021-2022 Kia Stinger, front; and 2018-2020 Kia Stinger, front. This part cross-references Raybestos Brakes (e.g., 982547FZN, 982547R) for the same application. The Brembo 09.D027.11 is a fitment-specific front rotor for drivers servicing Genesis G70 and Kia Stinger brake systems.

Common Brake Issues This Rotor Can Address

• Brake pulsation caused by rotor wear or thickness variation
• Noise and vibration from worn front rotors
• Corrosion on exposed rotor surfaces
• Reduced braking consistency from rotor wear near minimum thickness
• Uneven braking feel when replacing pads without matching rotor service

Installation Notes and Tips

Verify rotor diameter, thickness, and front position before installation. Clean the hub mounting surface, inspect calipers and pads for wear, and replace pads with the rotor when restoring braking performance. Use the included fixing screw kit during installation and confirm the rotor is within the 28 mm minimum thickness specification before service.

Quality Assurance

Brembo develops this UV Coated rotor as an OE-equivalent replacement for select Genesis G70 and Kia Stinger front brake applications. The part number 09.D027.11 is marked on the rotor along with minimum thickness information for service reference.