Cardone 12-10216 ABS Control Module

Cardone ABS Control Module for Windstar

Cardone ABS Control Module Part Number 12-10216 is a remanufactured brake control module built for 2001-2003 Ford Windstar models with traction control and without Interactive Vehicle Dynamics (IVD). It is engineered for direct bolt-on replacement and is not programmed, which helps streamline service on the correct application.

Key Features

• Remanufactured Original Equipment-style ABS control module
• Fits 2001-2003 Ford Windstar with traction control, without IVD
• Bolt-on attachment method with 3 connectors
• Plastic module housing with male terminals
• No programming required for installation on the listed application
• 100% computer testing for consistent performance
• High-pressure hydraulic testing to verify zero leakage
• Air-decay testing to confirm the unit is free of brake fluid
• Critical components are re-soldered where needed to improve electrical connection quality
• Worn or failed components are replaced with new or rebuilt parts during remanufacturing

Product Details

This Cardone ABS Control Module 12-10216 is remanufactured to meet OE performance expectations for the Ford Windstar brake system. Cardone reverse-engineers failed units to identify original design issues, then corrects those weaknesses during the remanufacturing process. The result is a direct-fit ABS control module for 2001, 2002, and 2003 Ford Windstar vehicles equipped with traction control and not equipped with Interactive Vehicle Dynamics (IVD). This part cross-references Monroe Shocks & Struts (e.g., 172286, 182286) for the same application.

Common Issues This Part Addresses

• ABS warning light illuminated on the dash
• Traction control system fault messages or reduced traction control function
• Intermittent brake control module electrical failures
• Brake system communication or response problems tied to the ABS module
• Hydraulic leakage or internal module contamination concerns

Installation Notes

Compatible With 2001-2003 Ford Windstar, traction control models without Interactive Vehicle Dynamics (IVD). Verify connector count, terminal layout, and mounting style before installation. This module uses a bolt-on design and does not require programming on the listed fitment. Confirm the vehicle is the correct brake-system configuration before replacing the original unit.

Quality Assurance

Cardone remanufactured ABS Control Modules undergo computer testing, hydraulic pressure testing, air-decay testing, and on-car validation when required. The remanufacturing process replaces failed components and restores electrical integrity to support reliable ABS and traction control operation. Part Number 12-10216 is built as a remanufactured OE-style replacement for the specified Ford Windstar application.