Cardone 12-17239 ABS Control Module

Cardone ABS Control Module for Ford and Mercury

Restore ABS and traction control response with this remanufactured Cardone ABS Control Module, part number 12-17239. It is built for 2007-2008 Ford Explorer and 2007-2008 Mercury Mountaineer applications with the specified ID number, and it is engineered to meet or exceed original equipment performance.

Key Features

• Remanufactured Original Equipment-style ABS control module for a precise vehicle fit
• 100% computer testing for consistent electrical performance
• High-pressure hydraulic testing to verify zero leakage
• Air-decay testing to confirm the unit is free of brake fluid
• Critical components are re-soldered where needed to improve electrical connection quality
• Worn or non-functioning components are replaced with new or rebuilt parts during remanufacturing
• Plastic module housing with bolt-on attachment method
• No programming required for installation on the listed applications
• Two connectors and male terminals for the specified factory configuration

Detailed Description

Cardone ABS Control Module 12-17239 is a remanufactured brake control module designed for direct replacement in select Ford Explorer and Mercury Mountaineer models. The remanufacturing process is based on reverse engineering of failed units so original design issues can be identified and corrected, helping deliver reliable ABS and traction control operation when braking conditions change quickly. This Cardone ABS Control Module is built for the listed ID #(s) 7A24 2C219-CG application and is intended for vehicles that require the exact factory-style module configuration.

Cardone’s ABS Control Module line focuses on restoring OE-level function through thorough testing and component renewal. For drivers searching for a 2007-2008 Ford Explorer ABS control module or a 2007-2008 Mercury Mountaineer ABS module, part number 12-17239 provides a remanufactured replacement that matches the original mounting and connector layout.

What It Helps Fix

• ABS warning light caused by a failed control module
• Traction control faults tied to module electronics
• Intermittent brake system communication issues
• Loss of proper ABS pump and valve control
• Brake system errors related to internal solder or circuit failure

Installation Notes and Tips

Verify the module ID number before ordering and confirm the connector count, terminal layout, and bolt-on mounting style match the original unit. This part does not require programming on the listed applications, but the brake system should be inspected for stored fault codes and any related hydraulic or electrical issues before final installation. Because this is a brake control component, proper diagnostic procedures should be followed during replacement.

Quality Assurance

Cardone remanufactured ABS Control Modules are tested for electrical consistency, hydraulic integrity, and leak-free operation before release. The remanufacturing process also reduces energy and raw material use compared with producing a new part, supporting an earth-friendly repair approach. Part number 12-17239 is built to restore dependable ABS performance in the specified Ford Explorer and Mercury Mountaineer applications.