Cardone 14-1005 Disc Brake Caliper Bracket - Rear Left

Cardone Caliper Bracket for Rear Left Brake Service

Cardone Part Number 14-1005 is a remanufactured disc brake caliper bracket for rear left applications on select Ford, Lincoln, and Mercury vehicles. It is built from cast iron with rust protection on the bracket surface to support longer service life and consistent brake operation.

This Caliper Bracket line focuses on OE-style fit and function, with inspected and tested bolt threads for trouble-free installation. For drivers servicing a 1993 Ford Mustang rear left caliper bracket or a 1989-1992 Ford Taurus rear left caliper bracket, 14-1005 provides a direct replacement option.

Key Features

• Remanufactured to meet or exceed OE performance targets
• Cast iron construction for brake system durability
• Rust-protective coating helps extend bracket life
• Inspected and tested bolt threads support easier installation
• Grease pack included for brake service preparation
• Industry-wide application coverage for select rear left brake setups

Product Details

The Cardone Caliper Bracket brand line is built around remanufactured brake components that follow original design intent while correcting known OE design flaws where applicable. Part Number 14-1005 is a gray, remanufactured disc brake caliper bracket made for rear left use on compatible Ford, Lincoln, and Mercury platforms. This part cross-references Lincoln F1DZ2B512A for the same application.

Compatible With 1993 Ford Mustang, rear left; 1990-1992 Ford Cougar, rear left; 1989-1992 Ford Taurus, rear left; 1987-1992 Ford Thunderbird, rear left; 1988-1992 Lincoln Continental, rear left; 1991-1992 Lincoln Mark VII, rear left; 1987-1992 Mercury Cougar, rear left; and 1990-1992 Mercury Sable, rear left. Cardone 14-1005 is a practical choice when replacing a worn or corroded rear left caliper bracket on these vehicles.

Common Brake Issues Addressed

• Corroded or damaged rear left caliper bracket
• Uneven pad movement caused by bracket wear
• Brake noise related to bracket fit or surface condition
• Brake service problems from worn or stripped bolt threads
• Reduced brake consistency from a compromised bracket assembly

Installation Notes and Tips

Before installation, inspect the mounting points, pads, rotors, and brake hose condition. Clean the contact surfaces thoroughly and verify that the bolt threads are in good condition before torquing to specification. Use the brake fluid recommended by the original equipment manufacturer, and replace fluid from a sealed container when service calls for it.

For brake noise prevention, make sure the pads seat tightly in the caliper assembly and confirm the rotor finish is non-directional where required. If the vehicle shows a low brake pedal or pulls during braking, inspect the full hydraulic and pad condition before final assembly.

Quality Assurance

Cardone remanufactures caliper brackets to OE-level standards and tests critical threaded interfaces before release. The bracket is coated for rust protection, and the included grease pack supports proper brake service preparation. Part Number 14-1005 is built for dependable rear left brake replacement on the listed Ford, Lincoln, and Mercury applications.