Cardone 14-1103 Disc Brake Caliper Bracket - Rear Left or Rear Right

Cardone Rear Caliper Bracket for S10, Blazer, Jimmy

Cardone Part Number 14-1103 is a remanufactured disc brake caliper bracket built for rear left and rear right applications on select Chevrolet, GMC, Oldsmobile, and Isuzu vehicles. It is engineered to meet or exceed OE performance, with inspected bolt threads for a more straightforward installation and dependable brake service.

Key Features

• Remanufactured caliper bracket with OE-level performance targets
• Rust-protective coating helps extend service life
• Cast iron construction for strength and durability
• Grease pack included for installation prep
• Bracket design addresses original OE design flaws where applicable
• Fits rear left and rear right positions on listed applications

Product Details

The Cardone Caliper Bracket line focuses on restoring proper caliper support and brake pad alignment in disc brake systems. This gray cast iron bracket is remanufactured to Cardone standards, with attention to thread condition and fit consistency. Part 14-1103 is a direct-fit brake bracket solution for 1997-2005 Chevrolet Blazer, 1998-2005 GMC Jimmy, 1997-2004 Chevrolet S10, 1997-2004 GMC Sonoma, 1997-2001 Oldsmobile Bravada, and 1998-2000 Isuzu Hombre rear brake applications.

This part cross-references Chevrolet 18025478 and 18026155 for the same application.

What It Helps Address

• Brake noise caused by bracket or pad movement
• Uneven pad contact from worn or damaged caliper support
• Corrosion-related bracket wear in rear disc brake systems
• Installation issues from damaged or dirty bolt threads
• Brake service problems on Chevrolet Blazer, GMC Jimmy, and related platforms

Installation Notes

• Verify rear left or rear right position before installation.
• Inspect pads, rotors, slides, and hardware condition during brake service.
• Use the correct brake fluid specified by the vehicle manufacturer.
• Clean mounting surfaces and confirm bolt threads are free of damage before tightening.
• Follow factory torque specifications and brake service procedures.

Quality Assurance

Cardone remanufactures caliper brackets to meet or exceed OE performance standards, with inspected and tested bolt threads for reliable installation. The bracket is coated for rust protection and supplied with a grease pack to support proper brake service.