Cardone 18-8064 Disc Brake Caliper - Front Right

Remanufactured Disc Brake Caliper

The Cardone Unloaded Caliper 18-8064 is a remanufactured disc brake caliper built for consistent braking performance and OE-style fit. It is pressure-tested, finished in gray with an oil emulsion coating, and supplied with a hardware kit for a cleaner installation on the correct application.

Compatible With Chevrolet and Isuzu applications that use this caliper design, including Chevrolet and Isuzu brake service jobs where a remanufactured front or rear caliper is specified by the vehicle platform.

Key Features

• Remanufactured Original Equipment-style caliper for accurate vehicle fit
• Pressure-tested for consistent hydraulic performance
• Steel piston construction with 2-piston design
• Gray caliper finish with oil emulsion coating and rust inhibitor treatment
• New bleeder screws for positive sealing and easier bleeding
• New high-temperature EPDM rubber seals for extended service life
• Plastic cap plugs protect brake port threads during handling and installation
• Package contents: caliper and hardware kit

Product Details

Cardone remanufactured brake calipers are rebuilt with new premium components and checked for pressure integrity before release. Part number 18-8064 uses an M10x1.0 inlet and bleeder port size, a steel piston material, and a 2.12-inch (53.848 mm) piston diameter. The caliper bracket is included where applicable, and new banjo bolts, stainless steel hardware clips, and mounting pins are included where applicable. This part cross-references Chevrolet and Isuzu OE application numbers for the same brake service need.

Common Brake Issues It May Address

• Brake pull to one side during stopping
• Low or uneven brake pedal response caused by caliper wear or seal failure
• Brake fluid leakage at the caliper body or bleeder area
• Sticking or uneven piston movement from corrosion or pitting
• Brake noise related to worn caliper components

Installation Notes

Use the brake fluid specified by the vehicle manufacturer and replace fluid from a sealed container only. For floating caliper systems, silicone grease is used on the mounting pins. Bleed the system thoroughly after installation, and verify that the bleeder port and inlet port thread sizes match the vehicle’s brake line and hardware requirements. If the application calls for a bracket, confirm that the correct bracket is present before assembly.

Quality Assurance

Each Cardone Unloaded Caliper is remanufactured to rigorous quality standards, pressure-tested, and finished with corrosion protection to support reliable brake service. The remanufacturing process also reduces energy and raw material use compared with producing a new part.