Cardone 19-6235 Disc Brake Caliper - Front Right

Front Right Brake Caliper for Mitsubishi Lancer

Restore consistent braking with this remanufactured Cardone unloaded disc brake caliper, part number 19-6235. It is built for the front right position on 2003-2006 Mitsubishi Lancer models and is remanufactured with new premium components for dependable fit and function.

Cardone’s Unloaded Caliper line focuses on OE-style replacement calipers that are pressure-tested and finished for corrosion resistance. For Mitsubishi Lancer front brake service, 19-6235 provides the correct application details and a complete hardware kit for a cleaner installation.

Key Features

• Fits 2003-2006 Mitsubishi Lancer, front right
• Remanufactured disc brake caliper with OE-style fit
• Pressure-tested for consistent brake performance
• Aluminum piston design with 4 pistons and 40.005 mm piston size
• Gray finish with oil emulsion coating and rust inhibitor treatment
• New bleeder screw, new banjo bolts where applicable, and new stainless steel hardware clips where applicable
• Plastic cap plug protects brake port threads during installation
• Caliper bracket included where applicable
• Part number 19-6235

Product Details

This Cardone unloaded caliper is remanufactured to rigorous quality standards using brand-new internal components, including high-temperature EPDM rubber seals and durable pistons. The design is intended to match the original equipment fit on the Mitsubishi Lancer front right brake corner, helping maintain proper pedal feel and braking response. The Cardone 19-6235 is also a practical OE replacement for drivers servicing the front brake hydraulics on 2003, 2004, 2005, and 2006 Mitsubishi Lancer models.

This part cross-references Mitsubishi MR475930 for the same application.

Common Brake Issues It Can Address

• Brake fluid leakage at the caliper
• Uneven or inconsistent front braking
• Sticking or seized caliper operation
• Corrosion-related caliper wear
• Low brake pedal feel caused by caliper hydraulic faults

Installation Notes

• Verify the front right position before installation.
• Bleeder port size is M10x1.0 and inlet port size is M10x1.0.
• Use the brake fluid specified by the vehicle manufacturer.
• Inspect brake hoses, pads, and rotor condition during service.
• Follow proper bleeding procedures after installation to remove air from the system.

Quality Assurance

Each Cardone brake caliper is pressure-tested before release and remanufactured with new premium components for reliable operation. The process also reduces raw material and energy use compared with manufacturing a new part, while maintaining OE-style fit and finish for the Mitsubishi Lancer application.