Cardone 19-626 Disc Brake Caliper - Rear Right

Remanufactured Rear Right Caliper

Cardone 19-626 is a remanufactured disc brake caliper for the rear right position on select Nissan applications. It is built with new premium components, pressure-tested for consistent brake performance, and finished in gray with an oil emulsion coating for corrosion resistance.

This Cardone Unloaded Caliper line focuses on OE-style fit and straightforward serviceability for Nissan Maxima and Nissan 810 brake repairs. Part number 19-626 is supplied with a hardware kit and is engineered for a direct replacement on the listed rear right applications.

Key Features

• Remanufactured Original Equipment-style disc brake caliper
• Fits rear right brake applications on select 1981-1984 Nissan models
• Steel piston with 38.1762 mm outside diameter
• New high-temperature EPDM rubber seals for extended service life
• New bleeder screw for reliable bleeding and sealing
• Plastic cap plug protects brake port threads during installation
• Rust-inhibiting finish in gray oil emulsion coating
• Package contents: caliper and hardware kit

Detailed Description

Cardone 19-626 is a remanufactured rear right disc brake caliper designed for select Nissan Maxima and Nissan 810 vehicles. It is pressure-tested and assembled with new internal components, including seals, bleeder screw, and service hardware, to support dependable brake operation. The unloaded caliper design is intended for applications that reuse the brake pads and related pad service components as specified by the vehicle setup.

Compatible With 1982-1984 Nissan Maxima, rear right; 1981 Nissan 810, rear right from 07/1981; and 1981 Nissan Maxima, rear right from 07/1981. This part cross-references Nissan 4400104S90RE for the same application. Use Cardone 19-626 when servicing the rear right brake corner on these Nissan platforms.

What It Helps Address

• Brake drag or uneven rear braking at the right rear wheel
• Leaking caliper seals or fluid seepage at the caliper body
• Corroded or sticking piston movement
• Bleeding issues caused by a worn bleeder screw
• Brake pull related to caliper performance imbalance

Installation Notes and Tips

Verify the vehicle’s brake fluid specification on the master cylinder reservoir lid and use fresh fluid from a sealed container. For floating caliper mounting pins, use silicone grease. Confirm the rear right position, piston type, and bracket requirements against the vehicle before installation. The bleeder port size is M10x1.0, and the inlet port size is M10x1.0.

Quality Assurance

Each Cardone brake caliper is remanufactured to quality and performance standards, then 100% pressure-tested before release. The process uses new premium components and reduces raw material and energy use compared with manufacturing a new part.