Cardone 19-763 Disc Brake Caliper - Front Left

OE-Style Front Left Brake Caliper

Restore consistent braking on your 1983-1987 Honda Prelude with this Cardone Unloaded Caliper, part number 19-763. This remanufactured front left disc brake caliper is built for the Honda Prelude application and arrives with the hardware needed for a straightforward brake service.

Cardone 19-763 is remanufactured to OE fit standards, pressure-tested for brake performance, and finished with corrosion protection to support long-term service on the front left corner of the vehicle.

Key Features

• Fits 1983-1987 Honda Prelude, front left
• Cardone Unloaded Caliper, part number 19-763
• Remanufactured OE-style disc brake caliper
• Steel piston with 51.054 mm piston size
• Oil emulsion finish with gray caliper color
• New bleeder screw, seals, and service hardware included where applicable
• Plastic cap plug protects brake port threads during installation
• Pressure-tested for consistent brake operation

Product Details

This Cardone brake caliper is remanufactured from an original equipment core and rebuilt with new premium components for dependable operation. The caliper uses a steel piston, high-temperature EPDM rubber seals, and rust-inhibiting finish treatment to help maintain performance in demanding brake environments. The unloaded design is appropriate for applications that reuse the vehicle’s pad set and related brake components as specified by the service procedure.

This part cross-references Honda 45230SB0674 for the same application. Use Cardone 19-763 when servicing a front left brake caliper on a 1983-1987 Honda Prelude.

Common Brake Issues This Part Addresses

• Brake fluid leakage at the caliper body or piston seal
• Uneven braking at the front left wheel
• Sticking or seized caliper piston movement
• Corrosion-related brake drag or poor release
• Low brake pedal feel caused by caliper seal wear or internal leakage

Installation Notes and Tips

Fits 1983-1987 Honda Prelude, front left. Verify the inlet port size is M10x1.0 and the bleeder port size is M10x1.25 before installation. Bleed the brake system with the brake fluid specified by the vehicle manufacturer, and always use fresh fluid from a sealed container. For floating caliper systems, use silicone grease on the mounting pins as noted in the service guidance.

Because this is an unloaded caliper, transfer or service the vehicle-specific brake components as required by the application. Confirm bracket and hardware requirements against the vehicle before beginning the repair.

Quality Assurance

Cardone remanufactures this caliper to rigorous quality and performance standards, then pressure-tests each unit before release. The process uses new components and OE-style finishing methods to support fit, sealing, and corrosion resistance on the Honda Prelude front left brake position.