Cardone 19-B6033 Disc Brake Caliper - Front Right

Front Right Brake Caliper for Toyota Venza

Restore consistent braking with this remanufactured Cardone unloaded disc brake caliper with bracket, part number 19-B6033. It is built for the front right position on 2009-2016 Toyota Venza models and uses a phenolic piston design for OE-style fit and function.

Key Features

• Fits 2009-2016 Toyota Venza, front right
• Cardone Unloaded Caliper w/Bracket line for OE-style brake service
• Remanufactured original equipment replacement for direct vehicle fit
• Phenolic piston construction with 2 pistons and 45.8978 mm piston size
• New bleeder screw, new seals, and new hardware kit included
• Bracket included where applicable for a complete front brake service
• Pressure-tested for consistent brake performance
• Oil emulsion finish with gray caliper color and rust inhibitor treatment

Product Details

Cardone 19-B6033 is a remanufactured disc brake caliper for the front right side of the Toyota Venza. The unloaded caliper with bracket configuration supports a clean replacement on the 2009-2016 Venza platform, and the phenolic piston design helps maintain proper brake response under heat and load. This part cross-references Toyota 477300T010 for the same application.

The Cardone Unloaded Caliper w/Bracket line focuses on OE-style replacement parts with new premium components, including high-temperature EPDM rubber seals, stainless steel hardware clips, and protective port caps to help preserve thread condition during installation. Cardone 19-B6033 is pressure-tested and remanufactured to meet rigorous quality and performance standards.

Common Brake Issues This Part Addresses

• Sticking or dragging front right brake caliper
• Uneven braking or vehicle pull during stops
• Brake fluid leakage at the caliper
• Corrosion-related caliper performance loss
• Poor pedal response caused by caliper wear or seal failure

Installation Notes

Use the correct brake fluid specified by the vehicle manufacturer and replace fluid from a sealed container. Bleed the brake system thoroughly after installation. For floating caliper mounting pins, use silicone grease. Verify the bleeder port size and inlet port size are M10x1.0 before installation. Confirm pad condition, rotor condition, and hose condition during service to avoid repeat brake concerns.

Quality Assurance

Each Cardone remanufactured caliper is pressure-tested and assembled with new premium components to support reliable brake operation. The remanufacturing process also reduces energy and raw material use compared with producing a new part.