Cardone 19-B6377 Disc Brake Caliper - Rear Left

Rear Left Brake Caliper for Subaru Applications

This remanufactured Cardone unloaded caliper with bracket is built for rear left brake service on select Subaru Forester, Legacy, and Outback models. Part number 19-B6377 is a direct-fit disc brake caliper solution for drivers replacing a worn, sticking, or leaking rear caliper.

Cardone 19-B6377 is remanufactured to OE-style fitment standards and pressure-tested for consistent brake performance. The gray caliper features an oil emulsion finish, a steel piston, and a 40.4622 mm piston size, with the bracket included where applicable for the listed Subaru rear left applications.

Key Features

• Remanufactured disc brake caliper for rear left installation
• Fits 2014-2018 Subaru Forester, rear left
• Fits 2010-2014 Subaru Legacy, rear left
• Fits 2010-2014 Subaru Outback, rear left
• Steel piston construction for load handling and durability
• New bleeder screw, seals, and related hardware components included in the remanufacturing process
• Oil emulsion finish with rust-inhibiting treatment
• Inlet port size: M10x1.0

Product Details

The Cardone Unloaded Caliper w/Bracket line focuses on OE-style replacement calipers that arrive ready for brake system service on the specified vehicle application. For this part, the bracket is included where applicable, and the caliper is remanufactured with new EPDM rubber seals, stainless steel hardware clips, and other premium replacement components. This makes 19-B6377 a practical choice for Subaru Forester, Legacy, and Outback rear brake repairs where the original caliper has corrosion, piston wear, or hydraulic leakage.

This part cross-references Subaru 26692AJ030 and 26692AJ050 for the same application.

Common Brake Problems This Part Can Address

• Rear brake drag caused by a sticking caliper piston
• Brake fluid leakage at the caliper body or bleeder area
• Uneven rear braking on the left side
• Corrosion-related caliper seizure on Subaru rear brake systems
• Soft or inconsistent brake response from a worn hydraulic caliper

Installation Notes and Tips

Confirm rear left placement, inlet port size M10x1.0, and piston style before installation. Use the brake fluid specified by the vehicle manufacturer and replace fluid from a sealed container. Bleeding the system after installation is required to remove air and restore pedal feel. If the vehicle uses floating caliper hardware, apply silicone grease to the mounting pins as directed by service procedures.

Quality Assurance

Each Cardone remanufactured caliper is pressure-tested to verify hydraulic integrity and consistent operation. The unit is rebuilt with new premium components and treated with a rust inhibitor to support long-term service on the listed Subaru brake applications.