Cardone 19-B7458 Disc Brake Caliper - Front Right

Remanufactured Front Right Brake Caliper

Restore consistent braking performance with this Cardone remanufactured disc brake caliper for the front right position. Built for 2016-2017 Honda Accord applications, Cardone 19-B7458 is pressure-tested and assembled with new premium components for dependable operation and a clean, complete replacement.

The Cardone Remanufactured Brake Caliper line focuses on OE-style fit and function with attention to critical wear items. This caliper includes a bracket where applicable, along with new hardware, slides, dust boots, a bleeder screw, and abutment clips to support a straightforward brake service on the Honda Accord front right corner.

• Fits 2016-2017 Honda Accord, front right
• Remanufactured floating disc brake caliper
• Aluminum caliper body with steel piston
• 57 mm piston diameter for the listed application
• Banjo inlet fitting with M10x1.0 inlet thread
• Bracket included
• Mounting hardware included
• Caliper slides, dust boots, bleeder screw, bleeder cap, and abutment clips included
• Gray finish with oil emulsion coating

Detailed Product Overview

Cardone 19-B7458 is a remanufactured brake caliper engineered for the front right side of the 2016-2017 Honda Accord. It uses a floating caliper design with a single steel piston and aluminum casting, helping maintain proper pad movement and hydraulic response in the specified brake system. Each unit is pressure-tested to verify performance before it leaves the remanufacturing process.

This part cross-references Honda OE part number 45018T3LA30 for the same application. If you are replacing a worn or sticking front right caliper on a Honda Accord, 19-B7458 provides the correct fitment details for that service.

Common Brake Issues This Part Can Address

• Uneven braking from a sticking front right caliper
• Brake drag caused by worn piston or slide components
• Fluid leakage at the caliper assembly
• Poor pad movement from damaged caliper hardware
• Brake pull during stops on the front axle

Installation Notes and Tips

Verify the inlet thread size, bracket style, and mounting points against the original caliper before installation. Use the brake fluid specified by the vehicle manufacturer, and bleed the system thoroughly after replacement to remove air from the hydraulic circuit. Floating caliper mounting pins should be lubricated with silicone grease, and all brake surfaces should be inspected for wear before returning the vehicle to service.

Quality Assurance

Cardone remanufactured brake calipers are rebuilt with new premium components and 100% pressure-tested for consistent brake performance. The caliper arrives with the hardware needed for the listed application, and the remanufacturing process is focused on reliable OE-style operation for the Honda Accord front right brake position.