Cardone 19-B7578 Disc Brake Caliper - Front Left

Front Left Brake Caliper for Subaru Impreza

This Cardone unloaded caliper with bracket is a remanufactured front left disc brake caliper for 2017-2021 Subaru Impreza applications. Built for direct OE-style fitment, Cardone 19-B7578 is supplied with a gray powder-coated finish and steel pistons for dependable braking service.

Key Features

• Fits 2017-2021 Subaru Impreza, front left
• Cardone Unloaded Caliper w/Bracket, part number 19-B7578
• Remanufactured original equipment-style replacement
• Powder-coated gray finish with rust inhibitor treatment
• Steel piston design with 2-piston configuration
• New bleeder screw, seals, and hardware kit included
• Plastic cap plugs protect brake port threads during installation
• Banjo bolts included where applicable

Product Details

Cardone 19-B7578 is a remanufactured disc brake caliper engineered for the front left position on Subaru Impreza models from 2017 through 2021. The caliper bracket is included, and the unit is pressure-tested to verify brake performance before it leaves the remanufacturing process. New EPDM rubber seals, stainless steel hardware clips, and mounting pins are used where applicable to support a clean installation and consistent operation. This part cross-references Subaru 26292FL09A and 26292FL09B for the same application.

Common Brake Issues This Part Can Address

• Uneven braking or pulling during stops on a Subaru Impreza
• Brake drag caused by a sticking front left caliper
• Fluid seepage from worn caliper seals or bleeder components
• Corrosion-related caliper movement problems
• Reduced brake response from a worn remanufactured caliper assembly

Installation Notes

Use the OE-specified brake fluid listed on the master cylinder reservoir cap and replace fluid from a sealed container. For floating caliper mounting pins, silicone grease is used. Bleed the brake system thoroughly after installation, and inspect hoses, pads, and rear brake adjustment if pedal feel remains low. Cardone 19-B7578 includes the bracket for this application, along with the hardware kit shown in the package contents.

Quality Assurance

Cardone remanufactures this caliper to OE-level fit and performance standards, then pressure-tests each unit for consistent brake operation. The process uses new premium components and reduces raw material and energy use compared with manufacturing a new part.