Cardone 1G-1813 Rack and Pinion Assembly

Cardone Rack and Pinion Assembly for Equinox and Torrent

Cardone 1G-1813 is a remanufactured manual rack and pinion assembly built for direct replacement on select Chevrolet Equinox and Pontiac Torrent applications. It is engineered with new premium wear components, protective coating, and a factory test drive process to verify operation under demanding conditions.

Key Features

• Remanufactured Original Equipment-style rack and pinion assembly for a precise vehicle fit
• Manual steering rack construction with aluminum casting material
• 100% replacement of rubber sealing components
• New spool valve seals and rack donut seals installed where applicable to reduce internal leakage
• Specialized lubricant applied for extended service life
• Protective coating helps resist corrosion and rust
• Factory test drive performed to verify on-car communications and performance
• Includes inner tie rods; outer tie rods are not included

Product Details

This Cardone Rack and Pinion Assembly, part number 1G-1813, is a standard replacement steering gear for vehicles using a manual rack with electronic power steering system architecture. The unit is remanufactured to rigorous quality and performance standards, with all rubber sealing components replaced and critical wear surfaces refreshed for dependable steering response. Cardone’s remanufacturing process also reduces raw material and energy use compared with producing a new part.

Fits 2005-2009 Chevrolet Equinox, N/A. Fits 2006-2009 Pontiac Torrent, N/A. This part cross-references Chevrolet 15896770 and Pontiac 19133700 for the same application.

Common Steering Issues This Part Can Address

• Excessive steering play or looseness in the rack
• Internal fluid leakage at seals and valve housings where applicable
• Rough or inconsistent steering feel
• Corrosion-related wear on the steering gear housing
• Noise or binding caused by worn internal rack components

Installation Notes

Verify steering system configuration and match the original rack length, input shaft dimensions, and mounting hole spacing before installation. This assembly includes inner tie rods and an instruction sheet; mounting brackets, outer tie rods, and gaskets or seals are not included. After installation, perform a professional alignment and inspect all steering connections for proper operation.

Quality Assurance

Each unit is remanufactured to CARDONE’s quality standards and tested on a factory drive cycle that simulates demanding operating conditions while checking vehicle communication functions. The process uses new sealing components, specialized lubricant, and corrosion-resistant finishing to support long-term reliability.