Cardone 1G-2671 Rack and Pinion Assembly

Electronic Power Steering Rack for Versa

Restore steering response with this remanufactured CARDONE Rack and Pinion Assembly, part number 1G-2671. It is built for 2007-2010 Nissan Versa applications with electronic power steering systems using a manual rack, and it includes inner tie rods for a direct replacement setup.

Key Features

• Remanufactured Original Equipment-style rack and pinion assembly for a precise vehicle fit
• Fits 2007-2010 Nissan Versa, N/A, with electronic power steering systems featuring a manual rack
• Includes inner tie rods
• All rubber sealing components are replaced during remanufacturing
• New spool valve seals and rack donut seals are installed where applicable to reduce internal leakage
• Specialized lubricant is applied for extended service life
• Factory test drive verifies operation under demanding conditions and checks on-car communications
• Protective black finish helps resist corrosion and rust
• Aluminum housing with black bellows and standard replacement grade construction

Product Details

CARDONE 1G-2671 is a remanufactured steering rack and pinion assembly engineered for Nissan Versa models from 2007 through 2010. This manual rack assembly is intended for vehicles equipped with electronic power steering systems that use this configuration, and it is supplied with inner tie rods for the listed application. The remanufacturing process replaces sealing components, applies specialized lubricant, and uses factory testing to confirm performance and communication function before release. This part cross-references Nissan 48001EM30A for the same application.

Common Steering Issues It May Address

• Excessive steering play or looseness
• Internal fluid leakage from worn seals
• Rough, inconsistent, or binding steering feel
• Noisy steering operation caused by worn internal components
• Corrosion-related wear on the steering rack housing

Installation Notes

Verify the vehicle’s steering system configuration before ordering, since this assembly is listed for Versa models with electronic power steering systems featuring a manual rack. Compare the input shaft dimensions, rack length, and mounting hole spacing to the original unit before installation. An instruction sheet is included in the package contents. Professional alignment is recommended after steering component replacement.

Quality Assurance

Each CARDONE rack and pinion assembly is remanufactured to rigorous quality and performance standards and tested under simulated extreme operating conditions. The process includes replacement of rubber sealing components, application of specialized lubricant, and verification of on-car communications to support reliable operation in the listed Nissan Versa applications. Part number 1G-2671 is built as a standard replacement for the specified fitment.