Cardone 1G-3017 Rack and Pinion Assembly

Electronic Power Steering Rack for Sentra

Restore steering response with this remanufactured CARDONE rack and pinion assembly for the 2007-2012 Nissan Sentra. Part number 1G-3017 is built as a standard replacement for vehicles using electronic power steering with a manual rack configuration, and it includes inner tie rods.

Key Features

• Remanufactured Original Equipment-style rack and pinion assembly
• Fits 2007-2012 Nissan Sentra, N/A
• Includes inner tie rods
• Aluminum casting with black steering rack finish and black bellows
• All rubber sealing components replaced during remanufacturing
• Specialized lubricant applied for extended service life
• Factory test drive verifies operation under demanding conditions and checks on-car communications
• Protective coating helps resist corrosion and rust
• Earth-friendly remanufacturing process reduces raw material and energy use versus making a new part

Product Details

CARDONE 1G-3017 is a remanufactured rack and pinion assembly engineered for direct replacement on the 2007-2012 Nissan Sentra. The unit is rebuilt with new premium components, including updated seals where applicable, polished micro-finish valve sleeves where used, and a specialized lubricant to support long-term performance. The aluminum housing measures 44.563 inches in rack length with a 12.500-inch mounting hole spacing, and the black finish adds corrosion protection. This part cross-references Nissan 48001ET80A for the same application.

Common Steering Issues This Part Can Address

• Excessive steering play or loose steering feel
• Internal fluid leakage from worn rack seals, where applicable
• Rough or inconsistent steering response
• Noise or binding from a worn steering rack assembly
• Failure of the original electronic power steering rack and pinion unit

Installation Notes

Fits 2007-2012 Nissan Sentra, N/A. Confirm the vehicle uses the electronic power steering system with a manual rack configuration before installation. Package contents include the rack and pinion assembly and an instruction sheet. Outer tie rods, mounting brackets, and gaskets or seals are not included unless specifically listed. Verify input shaft dimensions, mounting hole spacing, and rack length against the original unit before installation.

Quality Assurance

Each CARDONE rack and pinion assembly undergoes a factory test drive that simulates extreme operating conditions while checking on-car communication functions. The remanufacturing process replaces all rubber sealing components and uses premium replacement parts to support durability and reliable operation. Part number 1G-3017 is remanufactured to rigorous quality and performance standards for the 2007-2012 Nissan Sentra.