Cardone 1G-3022 Rack and Pinion Assembly

Electronic Power Steering Rack for Cube

Restore steering response with this remanufactured CARDONE rack and pinion assembly for the Nissan Cube. Part number 1G-3022 is built as a standard replacement with new premium internal components, protective coating, and a factory test drive process that verifies on-car communication and performance.

Compatible with 2009-2014 Nissan Cube models using electronic power steering systems with a manual rack, this CARDONE Rack and Pinion Assembly is remanufactured to OE fit standards for direct replacement service.

Key Features

• Remanufactured original equipment-style rack and pinion assembly
• All rubber sealing components are replaced
• New spool valve seals and rack donut seals installed where applicable
• Specialized lubricant applied for extended service life
• Factory test driven under extreme operating conditions
• Protective black finish helps resist corrosion and rust
• Aluminum casting material with black bellows
• Includes inner tie rods

Product Details

The CARDONE 1G-3022 rack and pinion assembly is engineered for the Nissan Cube steering system and remanufactured to rigorous quality and performance standards. The unit measures 40.375 inches in rack length, uses a 0.750-inch input shaft diameter, and features a 12.688-inch mounting hole spacing. CARDONE’s remanufacturing process replaces sealing components, applies specialized lubricant, and verifies operation through factory testing to help deliver consistent steering feel and reliable communication with the vehicle’s electronic power steering system.

This part cross-references Nissan 480011FC0B for the same application. The 1G-3022 is a practical OE-style replacement for drivers servicing a 2009-2014 Nissan Cube steering rack and pinion assembly.

What It Helps Address

• Excessive steering play or looseness
• Internal fluid seal wear where applicable
• Rough or inconsistent steering response
• Corrosion-related wear on the steering rack housing
• Noise or binding from a worn rack and pinion assembly

Installation Notes

Package contents include the rack and pinion assembly and an instruction sheet. Mounting brackets, outer tie rods, and gasket or seal components are not included unless specifically listed. Verify steering system configuration, input shaft dimensions, and mounting measurements before installation. A professional alignment is required after replacement.

Quality Assurance

CARDONE remanufactures this steering rack to OE fit standards and subjects each unit to a factory test drive that simulates demanding operating conditions while checking vehicle communication. The remanufacturing process also reduces energy and raw material use compared with producing a new part.