Cardone 20-2203 Power Steering Pump

Cardone Power Steering Pump 20-2203

Restore steering performance with this remanufactured Cardone power steering pump, part number 20-2203. It is built to meet or exceed original equipment performance for select Chrysler Pacifica applications, including 2007-2008 models.

Key Features

• Remanufactured Original Equipment-style power steering pump for a precise vehicle fit
• All critical components, including cam packs and spool valves, are triple-tested for reliability
• Final assembly is computer-tested for pressure, bypass, fluid flow, valve operation, steering effort, and noise
• Built with 100% new O-rings and premium HNBR seals to help resist heat-related seal breakdown
• Aluminum housing with a press-on pulley attachment type and threaded outlet connection
• Supplied with a hydraulic pump, instruction sheet, and sealing kit
• Earth-friendly remanufacturing process reduces energy and raw material use versus producing a new part

Product Details

Cardone Power Steering Pump 20-2203 is a remanufactured hydraulic pump for vehicles using a remote reservoir setup. It features a hose barb inlet, a threaded outlet with 16x1.5 thread size, and a single outlet configuration. The pump is supplied without a reservoir or pulley, and the reservoir cap is not included. This part cross-references Chrysler 4880348AB for the same application.

Compatible With 2007 Chrysler Pacifica and 2008 Chrysler Pacifica, this pump is a direct-fit replacement for the listed applications. Use the correct OE fluid and follow the required system flush procedure for warranty-related service on the 2007 Chrysler Pacifica application.

Common Repair Uses

• Whining or noisy power steering pump operation
• Hard steering effort caused by pump wear or internal leakage
• Low or inconsistent hydraulic assist at idle
• Pressure loss from worn valves, seals, or internal components
• Steering performance issues after contamination or fluid breakdown

Installation Notes

• Inspect the pulley fit before installation; a damaged or mushroomed shaft can require pulley replacement.
• Bleed the system thoroughly after installation to remove trapped air and foam.
• Check fluid condition and flush the system if contamination is present.
• Some systems require a vacuum pump to fully remove air from the steering circuit.
• Verify the remote reservoir setup, hose connections, and outlet thread size before installation.

Quality Assurance

Each unit is hydraulically efficiency-tested and computer-tested to confirm pressure, flow, valve operation, steering effort, and noise. Cardone remanufacturing also includes upgraded wear surfaces where applicable, tested pressure relief valves, and premium seal materials for dependable service.