Cardone 20-386P1 Power Steering Pump

Remanufactured Power Steering Pump for Ford F-150

Restore steering response with this Cardone remanufactured power steering pump, part number 20-386P1. It is built for the 2009 Ford F-150 and supplied with a press-on pulley for the listed application.

Key Features

• Remanufactured Original Equipment-style power steering pump for a precise vehicle fit
• Triple-tested critical components, including cam packs and spool valves, for dependable operation
• 100% new O-rings and premium HNBR seals to help resist leaks and high-temperature breakdown
• Computer-tested final assembly checks pressure, bypass, fluid flow, valve operation, steering effort, and noise
• Surfaced shafts help reduce premature seal wear and extend service life
• Supplied with a tested and calibrated pressure relief valve
• Cast iron housing with O-ring hose port and threaded outlet

Product Details

Cardone Power Steering Pump 20-386P1 is remanufactured to meet or exceed original equipment performance targets. The remanufacturing process includes inspection and design review of the original unit, with upgrades used where applicable to improve durability. This pump is intended for the 2009 Ford F-150 and is listed with a remote reservoir setup, reservoir not included, and a 16x1.5 threaded outlet. Cardone 20-386P1 is a practical OE replacement for drivers addressing steering noise, low assist, or fluid leakage on the Ford F-150 platform.

This part cross-references Ford 9L3Z3A674B for the same application.

Common Repair Uses

• Hard steering at idle or low engine speed
• Whining or groaning from the power steering system
• Fluid leaks from worn seals or fittings
• Inconsistent steering assist after pump failure
• Loss of hydraulic pressure in the steering system

Installation Notes

Fits 2009 Ford F-150, N/A. Before 12/01/2008. Reservoir not included. Use the supplied sealing kit during installation, and verify pulley fit before assembly. If the original pulley has a loose fit on the replacement shaft, replace the pulley. Flush the system, inspect for contamination, and install an in-line filter when recommended for warranty protection. Use the vehicle manufacturer’s specified power steering fluid and check for binding steering components before replacing the pump.

Quality Assurance

Every unit undergoes hydraulic efficiency testing and final computer testing to verify pressure, bypass performance, fluid flow, valve operation, steering effort, and noise. Cardone’s remanufacturing process also reduces raw material and energy use compared with producing a new part.