Cardone 22-1018 Rack and Pinion Assembly

Remanufactured Steering Rack for Express and Savana

Cardone 22-1018 is a remanufactured electronic power steering rack and pinion assembly built for direct-fit replacement in select Chevrolet Express and GMC Savana vans. It is rebuilt with new premium components, tested under simulated road conditions, and finished for corrosion resistance to support dependable steering performance.

Key Features

• Remanufactured Original Equipment-style rack and pinion assembly for accurate vehicle fit
• New spool valve seals and rack donut seals installed to reduce internal leakage where applicable
• 100% replacement of rubber sealing components
• Specialized lubricant applied for extended service life
• Factory test drive verifies operation and on-car communications under demanding conditions
• Protective coating helps resist rust and corrosion
• Includes tie rod ends, sealing kit, and instruction sheet
• Steel and aluminum construction with black finish

Product Details

This Cardone Rack and Pinion Assembly, part number 22-1018, is engineered for vehicles that use electronic power steering rack and pinion hardware. The unit measures 53.50 inches in rack length, uses an O-ring hose port type, and features M18 x 1.5 pressure port threads and M16 x 1.5 return port threads. It has four mounting holes, a 3.25 lock-to-lock turn ratio, and a 0.79-inch input shaft diameter. For buyers searching for a remanufactured steering rack for Chevrolet Express 1500, GMC Savana 1500, or a hydraulic rack and pinion assembly for Chevrolet Express 2500 and GMC Savana 2500, this part is built to match the listed applications. This part cross-references Chevrolet and GMC OE numbers 19207099 and 19330573 for the same application.

What It Helps Fix

• Hard steering during the first minutes of driving
• Power steering pump whine caused by air in the system after replacement
• Steering that does not return to center after a turn
• Internal bypass from worn spool valve sealing surfaces
• Leaks from worn rack seals or sealing components

Installation Notes and Fitment

• Fits 2003-2014 Chevrolet Express 1500, N/A; install an in-line filter, use OE fluid, and flush the hydraulic power system during installation.
• Fits 2003-2014 GMC Savana 1500, N/A; install an in-line filter, use OE fluid, and flush the hydraulic power system during installation.
• Fits 2003-2006 Chevrolet Express 2500, N/A; with 7300 lb GVW, includes inner tie rods, and uses hydraulic power.
• Fits 2003-2006 GMC Savana 2500, N/A; with 7300 lb GVW, includes inner tie rods, and uses hydraulic power.
• Fits 2003 Chevrolet Express 2500, N/A; install an in-line filter and flush the hydraulic power system for warranty validation.
• Fits 2003 GMC Savana 2500, N/A; install an in-line filter and flush the hydraulic power system for warranty validation.

Before installation, verify port thread sizes, mounting-hole spacing, and steering system configuration. Bleed the system completely after service to remove trapped air and restore proper steering feel. If the vehicle does not return to center, inspect front-end alignment and check the return line for restriction or kinking.

Quality Assurance

Cardone remanufactures this rack and pinion assembly to rigorous quality and performance standards using new sealing components and specialized lubricant. Each unit is factory test driven to confirm operation under extreme conditions and verify on-car communications. The remanufacturing process also reduces energy and raw material use compared with producing a new part.