Cardone 22-184 Rack and Pinion Assembly

Remanufactured Electronic Power Steering Rack

Cardone 22-184 is a remanufactured rack and pinion assembly built for direct replacement in select Chevrolet, Pontiac, and Oldsmobile applications. It is rebuilt with new sealing components, specialized lubricant, and protective coating to support long-term steering performance and corrosion resistance.

This CARDONE rack and pinion assembly is engineered for vehicles such as the Chevrolet Malibu, Pontiac Grand Am, and Oldsmobile Alero, with OE-style fitment and on-car communication verification during testing. Part number 22-184 is also listed with tie rod ends included and a black finish for a clean replacement installation.

Key Features

• Remanufactured Original Equipment-style rack and pinion assembly
• 100% replacement of rubber sealing components
• New spool valve seals and rack donut seals installed where applicable
• Factory test drive performed under extreme operating conditions
• Protective coating helps resist rust and corrosion
• Specialized lubricant applied for extended service life
• Steel and aluminum casting materials
• O-ring hose port type with M18 x 1.5 pressure port and M16 x 1.5 return port
• Rack length: 45.50 in; total turns lock to lock: 2.88

Product Details

Cardone’s rack and pinion remanufacturing process focuses on restoring steering response, sealing integrity, and communication performance for electronic power steering systems. Each unit is tested to verify operation under demanding conditions, while worn rubber components are replaced and critical internal surfaces receive attention for durability. This makes 22-184 a practical replacement for drivers searching for a remanufactured steering rack for 1998-2005 Chevrolet Malibu, Pontiac Grand Am, or Oldsmobile Alero applications.

This part cross-references Chevrolet, Oldsmobile, and Pontiac OE numbers for the same application. Part number 22-184 is a direct-fit steering replacement for select GM platforms, including the Chevrolet Classic, Oldsmobile Cutlass, and Pontiac Grand Am.

Common Steering Issues It May Address

• Steering effort that is hard during the first few minutes of driving
• Internal fluid bypass or leakage in the rack and pinion assembly
• Steering that does not return to center after a turn
• Power steering pump whine caused by air in the system after service
• Corrosion or wear in the steering rack housing and seals

Installation Notes and Tips

For listed applications, install an in-line filter and use OE fluid. Flush the hydraulic power steering system when installing a rack and pinion assembly with inner tie rods for warranty validation. Bleed the system completely after installation to remove trapped air and reduce pump noise. Verify front-end alignment and inspect the return line for kinks or restrictions if steering does not return to center.

Quality Assurance

Each CARDONE electronic power steering rack and pinion undergoes a factory test drive that simulates extreme operating conditions and checks on-car communications. The remanufacturing process replaces sealing components, applies specialized lubricant, and uses a protective finish to support durability and consistent performance.

• Fits 2004-2005 Chevrolet Classic, N/A
• Fits 1999-2005 Pontiac Grand Am, N/A
• Fits 1999-2004 Oldsmobile Alero, N/A
• Fits 1998-2003 Chevrolet Malibu, N/A
• Fits 1998-1999 Oldsmobile Cutlass, N/A