Cardone 22-233 Rack and Pinion Assembly

Cardone Electronic Power Steering Rack

Cardone 22-233 is a remanufactured rack and pinion assembly built for precise steering response and OE-style fit. It is engineered for 1997-1998 Ford Mustang applications and includes new sealing components, a protective finish, and a factory test drive process that verifies operation under demanding conditions.

Key Features

• Remanufactured Original Equipment-style rack and pinion assembly for a direct vehicle fit
• Fits 1997-1998 Ford Mustang, N/A
• New spool valve seals and rack donut seals installed to reduce internal leakage
• Specialized lubricant applied to support longer service life
• Factory test driven to confirm performance and on-car communications
• Protective coating helps resist corrosion and rust
• Aluminum housing with black finish
• Includes rack and pinion, rubber bushings, sealing kit, and instruction sheet

Product Details

This Cardone rack and pinion assembly is built for Ford Mustang steering systems that need restored hydraulic steering control and consistent road feel. Part number 22-233 is remanufactured to strict quality standards, with all rubber sealing components replaced and polished micro-finish sleeves used where applicable for added durability. The assembly measures 48.50 inches in rack length, uses a 0.73-inch input shaft diameter, and features Teflon hose ports with 9/16 x 18 pressure port threads and 5/8-18 return port threads.

For 1997-1998 Ford Mustang owners searching for a remanufactured steering rack and pinion assembly, Cardone 22-233 provides a direct-fit replacement built to restore steering precision. This part cross-references Ford F6SZ3280BA for the same application.

Common Problems This Part Can Address

• Steering that feels hard during the first few minutes of driving
• Internal fluid bypass caused by worn rack seals
• Power steering leaks from aging sealing components
• Steering that does not return to center after a turn
• Noise or whine after rack replacement when air remains in the system

Installation Notes

For 1997-1998 Ford Mustang installation, use OE fluid and install an in-line filter. Flush the hydraulic power steering system when replacing the rack and pinion assembly, especially when inner tie rods are involved, to support warranty validation. Bleed the system completely after installation to remove trapped air and reduce pump whine.

Quality Assurance

Cardone remanufactures this steering rack to rigorous performance standards and tests each unit on a factory drive cycle that simulates severe operating conditions while checking vehicle communication. The remanufacturing process also reduces energy and raw material use compared with producing a new part.