Cardone 22-249 Rack and Pinion Assembly

Cardone 22-249 Rack and Pinion Assembly

Cardone 22-249 is a remanufactured electronic power steering rack and pinion assembly built for direct-fit replacement in select Ford, Lincoln, and Mercury full-size sedans. It is engineered for vehicles such as the Ford Crown Victoria, Lincoln Town Car, and Mercury Grand Marquis, with OE-style fitment and hydraulic power steering applications.

Key Features

• Remanufactured Original Equipment-style rack and pinion assembly for accurate vehicle fit
• Brand-new rubber sealing components installed to help reduce internal leakage
• Specialized lubricant applied to support longer service life
• Factory test drive performed under demanding operating conditions
• Protective coating helps resist corrosion and rust
• Aluminum casting material with black finish
• Includes inner tie rods and sealing kit
• O-ring hose port type with 2 mounting holes

Product Details

The Cardone Rack and Pinion Assembly, part number 22-249, is remanufactured to meet rigorous quality and performance standards. CARDONE replaces all rubber sealing components, installs new spool valve seals and rack donut seals where applicable, and applies a specialized lubricant to improve durability. Each unit is factory test driven to verify operation and on-car communications before release. This part cross-references Ford OE numbers such as 3W1Z3280BA and 3W1Z3504FARM for the same application.

Compatible With 2003-2007 Ford Crown Victoria, 2003-2007 Lincoln Town Car, 2003-2007 Mercury Grand Marquis, and 2008 Mercury Grand Marquis built before 01/01/2008. It is also listed for 2003-2004 Ford Grand Marquis applications. The rack measures 50.00 inches in length, has a total lock-to-lock travel of 2.88 turns, and uses a 0.73-inch input shaft diameter.

Common Steering Issues This Part Can Address

• Hard steering during the first few minutes of driving
• Power steering pump whine caused by air in the system after service
• Steering that does not return to center after a turn
• Internal bypass from worn spool valve sealing surfaces
• Fluid leakage from worn rack seals

Installation Notes and Tips

For warranty purposes, flush the hydraulic power steering system, use the suggested OE fluid, and install an in-line filter when recommended for the application. If steering does not return to center, inspect front-end alignment and check the return line for restriction or kinks. After installation, bleed the system completely to remove trapped air and reduce pump noise. The package contents include the rack and pinion, sealing kit, and instruction sheet.

Quality Assurance

Cardone remanufactures this steering rack and pinion using an earth-friendly process that reduces the energy and raw material needed to produce a new part by 80%. The unit is tested for fit, function, and communication performance before it leaves the factory, supporting dependable service in Ford Crown Victoria, Lincoln Town Car, and Mercury Grand Marquis applications.