Cardone 22-371 Rack and Pinion Assembly

Electronic Power Steering Rack for Chrysler and Dodge

CARDONE 22-371 is a remanufactured electronic power steering rack and pinion assembly built for direct replacement in select 2005 Chrysler 300 and 2005 Dodge Magnum applications. It is rebuilt with new sealing components, specialized lubricant, and protective coating to support dependable steering performance and corrosion resistance.

Key Features

• Remanufactured Original Equipment-style fit for the listed Chrysler and Dodge applications
• New spool valve seals and rack donut seals to reduce internal leakage where applicable
• 100% replacement of rubber sealing components
• Factory test drive verification under simulated extreme operating conditions
• Protective finish to help resist rust and corrosion
• Aluminum housing with black steering rack finish
• O-ring hose port type with M18 x 1.5 pressure port and M16 x 1.5 return port
• Tie rod ends included

Product Details

This CARDONE rack and pinion assembly is engineered for vehicles that use electronic power steering communication and hydraulic connections. The remanufacturing process replaces worn sealing parts, adds specialized lubricant for extended service life, and verifies on-car communication during testing. CARDONE 22-371 is listed for Fits 2005 Chrysler 300, N/A and Fits 2005 Dodge Magnum, N/A, making it a focused replacement for steering systems that need restored rack performance and consistent road feel.

This part cross-references Chrysler and Dodge OE numbers, including 4782341AD and 68002075AA, for the same application.

Common Problems This Part Can Address

• Hard steering during the first few minutes of driving
• Internal bypass or fluid leakage in the rack and pinion assembly
• Steering pump whine caused by air in the system after replacement
• Steering that does not return to center after a turn
• Wear-related “morning sickness” symptoms from internal seal and housing wear

Installation Notes and Tips

For 2005 Chrysler 300 and 2005 Dodge Magnum applications, install an in-line filter, use OE fluid, and flush the hydraulic power system when installing the rack and pinion assembly with inner tie rods for warranty validation. Bleed the steering system completely after installation to remove trapped air and reduce pump noise. If the vehicle does not return to center, inspect front-end alignment and check the return line for restriction or kinks.

Quality Assurance

CARDONE remanufactures this rack and pinion assembly to rigorous quality and performance standards. Each unit is factory test driven, sealed components are replaced, and a specialized lubricant is applied to support durability and reliable operation.