Cardone 26-2037 Rack and Pinion Assembly

Cardone Electronic Rack and Pinion for Lincoln Aviator

Restore precise steering response with this remanufactured Cardone rack and pinion assembly for the 2003-2005 Lincoln Aviator. Part number 26-2037 is built for direct OE-style fitment and includes new sealing components, a protective finish, and a factory test drive process that verifies operation under demanding conditions.

Key Features

• Remanufactured Original Equipment-style rack and pinion assembly for the Lincoln Aviator
• Part number 26-2037 with aluminum casting and black finish
• Includes tie rod ends, EVO kit, sealing kit, and instruction sheet
• All rubber sealing components are replaced during remanufacturing
• Specialized lubricant is applied for extended service life
• Factory test drive checks performance and on-car communications
• Protective coating helps resist corrosion and rust
• Rack length: 50.25 in; total turns lock to lock: 3.06

Product Details

Cardone’s Rack and Pinion Assembly line focuses on remanufactured steering components built to OE fit and function. This 26-2037 unit is engineered for the 2003-2005 Lincoln Aviator and uses premium replacement parts, including new spool valve seals and rack donut seals where applicable, to reduce internal leakage and maintain consistent steering feel. The aluminum housing, O-ring hose ports, and polished micro-finish sleeves where applicable support durability in everyday driving conditions. This part cross-references Lincoln OE numbers such as 2C5Z3280AA and 3C5Z3504AA for the same application.

Common Steering Issues This Part Can Address

• Hard steering during the first few minutes of driving
• Internal fluid bypass caused by worn rack seals
• Steering that does not return to center after a turn
• Power steering pump whine caused by air in the system after service
• Excessive steering play or inconsistent steering response

Installation Notes

Fits 2003-2005 Lincoln Aviator. This application is supplied without the EVO component and includes inner tie rods. An in-line filter is available, and Cardone recommends installing a filter and using OE fluid for warranty purposes. Flush the hydraulic power steering system thoroughly before installation, and bleed the system completely after service to remove trapped air. If the vehicle does not return to center, inspect front-end alignment and check the return line for restriction or kinks.

Quality Assurance

Each Cardone remanufactured rack and pinion assembly is processed to rigorous quality and performance standards, then factory test driven to verify operation under load and communication behavior. The remanufacturing process replaces rubber sealing components and uses new premium parts to support long-term reliability while reducing raw material and energy use compared with producing a new part.