Cardone 26-3013 Rack and Pinion Assembly

Remanufactured Electronic Steering Rack

Cardone 26-3013 is a remanufactured rack and pinion assembly built for precise steering response and OE-style fitment. It is engineered for 2002-2006 Nissan Altima applications and includes new sealing components, a sealing kit, and an instruction sheet for service work.

This Cardone Rack and Pinion Assembly line focuses on remanufactured OE replacement steering components with factory-style fit and verified operation. For Nissan Altima steering repair, 26-3013 is built to restore hydraulic steering performance while using updated internal sealing and protective finishing.

Key Features

• Remanufactured Original Equipment-style rack and pinion assembly
• Fits 2002-2006 Nissan Altima, N/A
• New spool valve seals and rack donut seals installed where applicable
• Specialized lubricant applied for extended service life
• Factory test drive performed to verify operation and on-car communications
• Protective coating helps resist corrosion and rust
• Steel and aluminum casting materials
• O-ring hose port type with M14 x 1.5 pressure port and M16 x 1.5 return port
• Tie rod ends included
• Part number 26-3013

Product Details

Cardone 26-3013 is a remanufactured steering rack designed for direct replacement in Nissan Altima models from 2002 through 2006. It measures 49.63 inches in rack length, uses a 0.75-inch input shaft diameter, and has 2 mounting holes spaced 10.75 inches apart. The assembly is finished in black and built with steel and aluminum casting materials for service durability. The unit is tested under simulated operating conditions to confirm steering function and communication performance before release.

This part cross-references Nissan 49001ZB000 and 490018J000 for the same application.

Common Steering Issues It May Address

• Hard steering during the first few minutes of driving
• Internal fluid bypass caused by worn rack seals
• Steering that does not return to center after a turn
• Power steering pump whine caused by air in the system after service
• Leakage from worn sealing components in the steering rack

Installation Notes

For 2002-2006 Nissan Altima installation, use an in-line filter and OE fluid, and flush the hydraulic power steering system when installing the rack and pinion assembly with inner tie rods for warranty validation. Bleed the steering system completely after installation to remove trapped air and verify smooth operation. Check front-end alignment and inspect the return line for restriction or kinks if the steering does not return to center.

Quality Assurance

Each Cardone electronic power steering rack and pinion is remanufactured to rigorous quality and performance standards, then factory test driven to verify operation under demanding conditions. Rubber sealing components are replaced, specialized lubricant is applied, and the unit is finished with protective coating to support long-term service life. The remanufacturing process also reduces energy and raw material use compared with producing a new part.